skip to main content
OSTI.GOV title logo U.S. Department of Energy
Office of Scientific and Technical Information

Title: Identifying Electronic Properties Relevant to Improving Stability in a-Si:H-Based Cells and Overall Performance in a-Si,Ge:H-Based Cells; final Subcontract Report, 18 April 1994-15 January 1998

Technical Report ·
DOI:https://doi.org/10.2172/6699· OSTI ID:6699
 [1]
  1. Department of Physics and Materials Science Institute, University of Oregon

The work carried out by the University of Oregon Under this subcontract focused on the characterization and evaluation of low-gap (a-Si,Ge:H) alloy materials and on issues related to overall stability in the mid-gap (a-SiH) materials. First, researchers characterized an extensive series of Uni-Solar a-Si,Ge:H samples using drive-level capacitance profiling and the analysis of sub-band-gap photocapacitance and photocurrent spectra. Thus, several bands of deep defect transitions were identified. Researchers were able to verify that charged defects are responsible for the different observed defect bands in device-quality a-Si,Ge:H alloy material. Second, they reported results of their measurements on a-Si,Ge:H alloy ''cathodic'' samples produced at Harvard University; these samples were found to exhibit significantly lower defect densities in the high Ge composition range (>50at.% Ge) than alloy samples produced either by conventional glow discharge of photo-chemical vapor deposition. Third, they performed voltage pulse stimulated capacitance transient measurements on a-Si:H/a-Si,Ge:H heterostructure samples to look for carrier trapping states that might be associated with this interface; they found there was a clear signature of trapped hole emission extending over long times associated specifically with the interface itself in concentrations of roughly 10{sup 11} cm{sup -2}. Fourth, researchers reported the results on several hot-wire a-Si:H samples produced with varying hydrogen levels. Their studies indicate that hot-wire-produced a-Si:H, with H levels between 2-5at.%, should lead to mid-gap devices with superior properties. Finally, they discussed some results on glow-discharge material, as well electron-cyclotron-resonance-deposited a-Si:H grown under hydrogen dilution conditions, and confirmed that, in terms of deep-defect creation, such films exhibited improved stability compared to conventional glow-discharge material.

Research Organization:
National Renewable Energy Lab. (NREL), Golden, CO (United States)
Sponsoring Organization:
US Department of Energy (US)
DOE Contract Number:
AC36-99-GO10337
OSTI ID:
6699
Report Number(s):
NREL/SR-520-25802; ON: DE00006699; TRN: US200305%%1214
Resource Relation:
Other Information: PBD: 16 Nov 1998
Country of Publication:
United States
Language:
English