PRELIMINARY REPORT ON THE METAL POWDER SLIP CASTING PROCESS. PART I
Technical Report
·
OSTI ID:4330808
It has been shown that slip casting of stainless steel powder is a process which results in a highly dense sintered material. The slip casting process is described in detail and the raw materials, such as metal powders, deflocculants, etc., are discussed. It has been observed that the viscosity of the slip is not of prime importance in the process, but rather its pH value. The effect of the variables in the process on the density of the material in various stages of the process has been investigated. Careful selection of raw materials and the processing steps permit fabrication of slip castings of high green'' strength which can be easily handled without any danger of breakage even before sintering. Photomicrographs show the uniformity of grain structure of slip cast stainless steel. (auth)
- Research Organization:
- Penn-Texas Corp., New York
- NSA Number:
- NSA-12-006612
- OSTI ID:
- 4330808
- Report Number(s):
- NYO-8528
- Country of Publication:
- United States
- Language:
- English
Similar Records
SLIP CASTING OF METAL POWDERS. PART III. Final Report
Fabrication of silicon nitride parts by slip casting
PRELIMINARY REPORT ON THE METAL POWDER SLIP CASTING PROCESS. PART II
Technical Report
·
Wed Feb 11 23:00:00 EST 1959
·
OSTI ID:4267755
Fabrication of silicon nitride parts by slip casting
Conference
·
Fri Aug 01 00:00:00 EDT 1986
· Ceram. Eng. Sci. Proc.; (United States)
·
OSTI ID:7006981
PRELIMINARY REPORT ON THE METAL POWDER SLIP CASTING PROCESS. PART II
Technical Report
·
Thu May 01 00:00:00 EDT 1958
·
OSTI ID:4303496