High rate electron cyclotron resonance etching of GaN, InN, and AlN
- Sandia National Laboratories, Albuquerque, New Mexico 87185 (United States)
- Department of Materials Science and Engineering, University of Florida, Gainesville, Florida 32611 (United States)
- Department of Physics, Auburn University, Auburn, Alabama 36849 (United States)
Electron cyclotron resonance etch rates of GaN, InN, and AlN are reported as a function of pressure, microwave power, and radio-frequency (rf) power in a Cl{sub 2}/H{sub 2}/CH{sub 4}/Ar plasma at 170 {degree}C. The etch rates for GaN and InN increase as a function of rf power. At 275 W, the etch rates reach maximum values of 2850 and 3840 A/min, respectively. These are the highest etch rates reported for these materials. As a function of pressure, the etch rates reach a maximum value at 2 mTorr and then decrease as the pressure is increased to 10 mTorr. The GaN and AlN etch rates increase less than a factor of 2 as the microwave power is increased from 125 to 850 W whereas the InN etch rate increases by more than a factor of 3.5. The maximum etch rate for AlN obtained in this study is 1245 A/min at a microwave power of 850 W, 1 mTorr pressure, and 225 W rf power. Atomic force microscopy is used to determine root-mean-square roughness as a function of etch conditions for GaN and InN and, while very smooth pattern transfer can be obtained for a wide range of plasma conditions for GaN, the smoothness of the etched InN surface is more sensitive to rf power, microwave power, and process pressure. The surface composition of the GaN is characterized using Auger spectroscopy and has shown that the Ga:N ratio increases with increasing rf power or microwave power. {copyright} {ital 1995} {ital American} {ital Vacuum} {ital Society}
- Research Organization:
- Sandia National Laboratories (SNL), Albuquerque, NM, and Livermore, CA (United States)
- DOE Contract Number:
- AC04-94AL85000
- OSTI ID:
- 240463
- Journal Information:
- Journal of Vacuum Science and Technology. B, Microelectronics Processing and Phenomena, Vol. 13, Issue 5; Other Information: PBD: Sep 1995
- Country of Publication:
- United States
- Language:
- English
Similar Records
Etching processes for fabrication of GaN/InGaN/AlN microdisk laser structures
Comparison of ICl- and IBr-Based Plasma Chemistries for Inductively Coupled Plasma Etching of GaN, InN and AlN