Development of new ribbons and webbings for high performance parachutes
Development of a 46 ft ribbon parachute required design of new and improved narrow fabrics. These included a lightweight, low porosity, 550 lb reinforced selvage nylon ribbon; a low porosity 1000 lb nylon ribbon; and a 2400 lb Kevlar webbing. Tensile elongation, lateral contraction, and other mechanical properties were measured as a function of load at room and elevated temperature to evaluate the fabrics and determine possible sources of parachute porosity variation. The property changes were too small to cause the parachute porosity to change significantly during deployment. Broken fill yarns observed in some Kevlar suspension line webbing after parachute deployment led to high rate loading tests to investigate conditions that might cause fill breakage. It was shown that fill damage did not reduce the strength of Kevlar suspension lines.
- Research Organization:
- Sandia National Labs., Albuquerque, NM (USA)
- DOE Contract Number:
- AC04-76DP00789
- OSTI ID:
- 5237097
- Report Number(s):
- SAND-84-0272C; CONF-840496-4; ON: DE84006484
- Resource Relation:
- Conference: 8. AIAA aerodynamic decelerator and balloon technology conference, Hyannis, MA, USA, 2 Apr 1984; Other Information: Portions are illegible in microfiche products
- Country of Publication:
- United States
- Language:
- English
Similar Records
Exploratory testing of supersonic ribbon parachutes in the NASA Ames 9-ft by 7-ft wind tunnel
Parachute materials
Related Subjects
PARACHUTES
MATERIALS
ARAMIDS
MATERIALS TESTING
NYLON
POROSITY
STATIC LOADS
TENSILE PROPERTIES
MECHANICAL PROPERTIES
ORGANIC COMPOUNDS
ORGANIC POLYMERS
PETROCHEMICALS
PETROLEUM PRODUCTS
PLASTICS
POLYAMIDES
POLYMERS
SYNTHETIC MATERIALS
TESTING
420200* - Engineering- Facilities
Equipment
& Techniques