Study of raised bridgewires in a pyrotechnic device
Recent tests with actuators containing TiH/sub 0/./sub 65/-KC10/sub 4/ and conventional bridgewires have shown potential problems. Experiments have been conducted with raised bridgewires to try to demonstrate that they will give more reliable ignition. The test units were heated to 185/sup 0/F for five hours, then cooled to -85/sup 0/F for three hours, and the cycle repeated an additional six times. Following the thermal shock test, the units were exposed to a mechanical shock of 1500 g (200 ..mu..s pulse-approximate haversine) at ambient temperature. The acceleration was in a direction such that the powder column was forced away from the bridgewire. Each unit received a nondestructive Electrothermal Response Test (ETR) after fabrication and after each of the two environmental tests. The ETR tests showed that the thermal contact between the bridgewire and the powder was not degraded after exposure to the two environments. Each unit was ignited by an electrical pulse while being maintained at a low temperature. Each unit ignited and gave a satisfactory output. It was concluded that a thin layer of powder around the bridgewire is sufficient to render any wall effect negligible and that the principle of the raised bridgewire in contact with TiH/sub 0/./sub 65/-KC10/sub 4/ is worthy of further study, especially for use with ceramic headers which have a significantly higher thermal conductivity than glass headers.
- Research Organization:
- Sandia Labs., Albuquerque, NM (USA)
- DOE Contract Number:
- EY-76-C-04-0789
- OSTI ID:
- 7300374
- Report Number(s):
- SAND-76-0725
- Country of Publication:
- United States
- Language:
- English
Similar Records
Simulation of powder-decoupling phenomena in electro-explosive devices by thermomechanical analysis (TMA)
Potassium perchlorate reaction with pyrotechnic fuels