skip to main content
OSTI.GOV title logo U.S. Department of Energy
Office of Scientific and Technical Information

Title: Characterizing composition modulations in InAs/AlAs short-period superlattices

Journal Article · · Physical Review, B: Condensed Matter
 [1]; ; ; ;  [2];  [3]; ; ;  [4]
  1. Center for Microanalysis of Materials, University of Illinois, Urbana, Illinois 61801-2985 (United States)
  2. Physical and Chemical Sciences Center, Sandia National Laboratories, Albuquerque, New Mexico 87185-1056 (United States)
  3. Department of Materials Science and Engineering, University of Michigan, Ann Arbor, Michigan 48109-2136 (United States)
  4. National Renewable Energy Laboratory, Golden, Colorado 80401-3393 (United States)

The formation of quantum wires has much interest due to their novel electronic properties which may lead to enhanced optoelectronic device performance and greater photovoltaic efficiencies. One method of forming these structures is through spontaneous lateral modulation found during the epitaxial growth of III/V alloys. In this paper, we report and summarize our investigations on the formation of lateral modulation in the molecular-beam epitaxy grown InAlAs/InP(001) system. This system was grown as a short-period superlattice where {ital n} monolayers of InAs are deposited followed by {ital m} monolayers of AlAs (with {ital n} and m{approximately}2) and this sequence is repeated to grow a low strain InAlAs ternary alloy on InP(001) that exhibits lateral modulation. Films were grown under a variety of conditions (growth temperature, effective alloy composition, superlattice period, and growth rate). These films have been extensively analyzed using x-ray diffraction, atomic force microscopy, and transmission electron microscopy (TEM) and microcharacterization, in addition to photon-based spectroscopes. Here we present results of several microstructural characterizations using a wide range of TEM-based techniques, and compare them to results from the other methods to obtain a unified understanding of composition modulation. Two strong points consistently emerge: (1) The lateral modulation wavelength is insensitive to growth temperature and effective alloy composition, but the strength of the lateral modulation is greatest near an effective alloy composition of In{sub 0.46}Al{sub 0.54}As, which corresponds to a slightly tensile global strain with respect to InP. (2) The composition variation for the strongly modulated films is as much as 0.38 InAs mole fraction. In addition, for these strongly modulated films, the modulation wave is asymmetric showing strongly peaked, narrower InAs-rich regions separated by flat AlAs-rich regions. We discuss these results and their possible implications in addition to detailing the techniques used to obtain them. {copyright} {ital 1999} {ital The American Physical Society}

OSTI ID:
690747
Journal Information:
Physical Review, B: Condensed Matter, Vol. 60, Issue 19; Other Information: PBD: Nov 1999
Country of Publication:
United States
Language:
English