10-T, 60 cm bore Nb/sub 3/Sn test module/coil design
Conference
·
· Adv. Cryog. Eng.; (United States)
OSTI ID:6202546
The coil concept is described; conductor configuration and verification test results are given. Particularly presented are those results concerning mechanical aspects of Nb/sub 3/Sn conductors. The verification tests indicate the 10 T, 60 cm bore, Nb/sub 3/Sn TMC will operate reliably. The procedure that allows increased bending of the conductor up to about 1% strain is heat treatment in a prebent shape. Also, the equal-area heat flux is higher than the maximum nucleate boiling limit. The maximum stress on the TMC conductor is calculated to be 132 MPa, which is less than 2/3 of the yield strength measured for a full-sized conductor at 4.2 K. This TMC is the first large coil using Nb/sub 3/Sn in a high current conductor.
- Research Organization:
- Japan Atomic Energy Research Institute, Tokai-mura, Ibaraki
- OSTI ID:
- 6202546
- Report Number(s):
- CONF-810835-
- Conference Information:
- Journal Name: Adv. Cryog. Eng.; (United States) Journal Volume: 27
- Country of Publication:
- United States
- Language:
- English
Similar Records
Experiment of 10-T, 60-cm-bore Nb/sub 3/Sn test module coil (TMC-1) for the cluster test program
A 42-cm bore superconducting coil using pre-reacted Nb/sub 3/Sn
Design of a 0. 6-m bore wind-and-react 12-T, 6-kA, Nb sub 3 Sn magnet
Journal Article
·
Sun May 01 00:00:00 EDT 1983
· IEEE Trans. Magn.; (United States)
·
OSTI ID:5535672
A 42-cm bore superconducting coil using pre-reacted Nb/sub 3/Sn
Conference
·
Mon Feb 29 23:00:00 EST 1988
· IEEE Trans. Magn.; (United States)
·
OSTI ID:6356611
Design of a 0. 6-m bore wind-and-react 12-T, 6-kA, Nb sub 3 Sn magnet
Conference
·
Thu Feb 28 23:00:00 EST 1991
· IEEE Transactions on Magnetics (Institute of Electrical and Electronics Engineers); (United States)
·
OSTI ID:5690556