Improved Techniques for Making P+-I-N+ Diode Detectors
Techniques for achieving a thin dead layer exhibiting low sheet resistance on the n+ side of a p+-i-n+ diode made by the lithium drift process were developed. A controlled quantity of lithium was diffused through a 1- to 2- micron phosphorus-doped layer on the silicon diode. The phosphorus-doped layer provided low sheet resistance. Because most of the lithium-diffused layer was drifted into the bulk material, dead layers of less than 7 microns thickness were achieved. Detectors made by this technique have given 23 kev (fwhm) resolution for gamma rays and monoenergetic electrons at room temperature, limited by diode noise. Detectors cooled to 78 to 195 deg K gave 6.5 kev resolution for Cs137 conversion electrons (625, 655 kev) and P207 x rays (74, 90 kev). Detectors stored without bias voltage at room temperature did not change performance over a four-month period. An analysis of the drift parameters show that the lithium drift rate depended upon the power dissipated in the diode during drift. An automatic control system was developed which allows the lithium drift operation to proceed at power dissipations in excess of 50 watts.
- Research Organization:
- Oak Ridge National Lab., Tenn.
- Sponsoring Organization:
- USDOE
- NSA Number:
- NSA-16-023900
- OSTI ID:
- 4806155
- Journal Information:
- IRE Transactions on Nuclear Science, Journal Name: IRE Transactions on Nuclear Science Journal Issue: 3 Vol. 9; ISSN 0096-2015
- Country of Publication:
- Country unknown/Code not available
- Language:
- English
Similar Records
High-resolution charged-particle spectroscopy with high-purity germanium detectors in the intermediate energy range
Quantification of Sheet Resistance in Boron-Diffused Silicon Using Micro-Photoluminescence Spectroscopy at Room Temperature