A fast reciprocating Langmuir probe for the DIII-D divertor
- and others
A new reciprocating Langmuir probe has been used to measure density and temperature profiles, ion flow, and potential fluctuation levels from the lower divertor floor up to the X-point on the DIII-D tokamak. This probe is designed to make fast (2 kHz swept, 20 kHz Mach, 500 kHz Vfloat) measurements with 2 mm spatial resolution in the region where the largest gradients on the plasma open flux tubes are found and therefore provide the best benchmarks for SOL and divertor numerical models. Profiles are constructed using the 300 ms time history of the probe measurements during the 25 cm reciprocating stroke. Both single and double null plasmas can be measured and compared with a 20 Hz divertor Thomson scattering system. The probe head is constructed of four different kinds of graphite to optimize the electrical and thermal characteristics. Electrically insulated pyrolytic graphite rings act as a heat shield to absorb the plasma heat flux on the probe shaft and are mounted on a carbon/carbon composite core for mechanical strength. The Langmuir probe sampling tips are made of a linear carbon fiber composite. The mechanical, electrical, data acquisition and power supply systems design will be described. Initial measurements will also be presented.
- Research Organization:
- Sandia National Labs., Albuquerque, NM (United States)
- Sponsoring Organization:
- USDOE Office of Energy Research, Washington, DC (United States)
- DOE Contract Number:
- AC04-94AL85000; AC03-89ER51114; FG03-95ER54294
- OSTI ID:
- 406151
- Report Number(s):
- SAND--96-2783C; CONF-960543--36; ON: DE97001326
- Country of Publication:
- United States
- Language:
- English
Similar Records
Reciprocating and fixed probe measurements of n{sub e} and T{sub e} in the DIII-D divertor
High heat flux Langmuir probe array for the DIII-D divertor plates