Skip to main content
U.S. Department of Energy
Office of Scientific and Technical Information

High dynamic range pixel architecture for advanced diagnostic medical x-ray imaging applications

Journal Article · · Journal of Vacuum Science and Technology. A, International Journal Devoted to Vacuum, Surfaces, and Films
DOI:https://doi.org/10.1116/1.2183298· OSTI ID:20777201
;  [1]
  1. School of Engineering Science, Simon Fraser University, Burnaby, British Columbia V5A 1S6 (Canada)

The most widely used architecture in large-area amorphous silicon (a-Si) flat panel imagers is a passive pixel sensor (PPS), which consists of a detector and a readout switch. While the PPS has the advantage of being compact and amenable toward high-resolution imaging, small PPS output signals are swamped by external column charge amplifier and data line thermal noise, which reduce the minimum readable sensor input signal. In contrast to PPS circuits, on-pixel amplifiers in a-Si technology reduce readout noise to levels that can meet even the stringent requirements for low noise digital x-ray fluoroscopy (<1000 noise electrons). However, larger voltages at the pixel input cause the output of the amplified pixel to become nonlinear thus reducing the dynamic range. We reported a hybrid amplified pixel architecture based on a combination of PPS and amplified pixel designs that, in addition to low noise performance, also resulted in large-signal linearity and consequently higher dynamic range [K. S. Karim et al., Proc. SPIE 5368, 657 (2004)]. The additional benefit in large-signal linearity, however, came at the cost of an additional pixel transistor. We present an amplified pixel design that achieves the goals of low noise performance and large-signal linearity without the need for an additional pixel transistor. Theoretical calculations and simulation results for noise indicate the applicability of the amplified a-Si pixel architecture for high dynamic range, medical x-ray imaging applications that require switching between low exposure, real-time fluoroscopy and high-exposure radiography.

OSTI ID:
20777201
Journal Information:
Journal of Vacuum Science and Technology. A, International Journal Devoted to Vacuum, Surfaces, and Films, Journal Name: Journal of Vacuum Science and Technology. A, International Journal Devoted to Vacuum, Surfaces, and Films Journal Issue: 3 Vol. 24; ISSN 1553-1813
Country of Publication:
United States
Language:
English

Similar Records

Low noise signal-to-noise ratio enhancing readout circuit for current-mediated active pixel sensors
Journal Article · Mon May 15 00:00:00 EDT 2006 · Journal of Vacuum Science and Technology. A, International Journal Devoted to Vacuum, Surfaces, and Films · OSTI ID:20777198

Signal readout in a-Si:H pixel detectors
Conference · Sun Aug 01 00:00:00 EDT 1993 · IEEE Transactions on Nuclear Science (Institute of Electrical and Electronics Engineers); (United States) · OSTI ID:5859032

Signal and noise analysis of a-Si:H radiation detector-amplifier system
Thesis/Dissertation · Sat Feb 29 23:00:00 EST 1992 · OSTI ID:10159346