Bubble Generation in the SNS 2 MW Mercury Target

Conference · Sun Aug 01 04:00:00 EDT 2021

OSTI ID:1831673

Barbier, Charlotte ^[1]; Weinmeister, Justin ^[1]; Rasheed, Fayaz ^[1]; Johns, Kevin C. ^[1]; Winder, Drew E. ^[1]; Riemer, Bernie ^[1]; Ottinger, Dustin ^[1]; Costa, Michael P. ^[1]; Sangrey, Robert L. ^[1]

---

1. ORNL

The accelerator at the Spallation Neutron Source is currently being upgraded to increase the proton beam power from 1.4 MW to 2.8 MW. About 2 MW will go to the first target station, while the rest will go to the future second target station. The first target station uses a mercury target. When the short proton beam pulse hits it, strong pressure waves are developed inside the mercury and the vessel itself, causing weld failures and cavitation erosion. The pressure wave can be significantly mitigated by injecting small helium bubbles into the mercury. SNS has been injecting helium since 2017 using small orifices but has met challenges in fabrication and operations with them. Thus, for the 2 MW target, swirl bubblers will be used to increase gas injection and improve reliability. A 2 MW prototypical target was built and tested in a mercury process loop available at Oak Ridge National Laboratory. Acrylic viewports on the top of the target were used to determine the bubble size distribution (BSD) generated by the swirl bubblers. It was found that the bubblers were not only capable of generating small bubbles but that the BSD was independent of gas injection rate.

• Research Organization: Oak Ridge National Laboratory (ORNL), Oak Ridge, TN (United States)
• Sponsoring Organization: USDOE; USDOE Office of Science (SC), Basic Energy Sciences (BES) (SC-22)
• DOE Contract Number: AC05-00OR22725
• OSTI ID: 1831673
• Country of Publication: United States
• Language: English