Skip to main content
U.S. Department of Energy
Office of Scientific and Technical Information

Verification of diesel spray ignition phenomenon in dual-fuel diesel-piloted premixed natural gas engine

Journal Article · · International Journal of Engine Research
 [1];  [2];  [2];  [2];  [3];  [1]
  1. National Inst. of Maritime, Port and Aviation Technology, Tokyo (Japan)
  2. Sandia National Lab. (SNL-CA), Livermore, CA (United States)
  3. Polytechnic Univ. of Valencia (UPV) (Spain)

Dual-fuel (DF) engines, in which premixed natural gas and air in an open-type combustion chamber is ignited by diesel-fuel pilot sprays, have been more popular for marine use than pre-chamber spark ignition (PCSI) engines because of their superior durability. However, control of ignition and combustion in DF engines is more difficult than in PCSI engines. In this context, here we focus on the ignition stability of n-heptane pilot-fuel jets injected into a compressed premixed charge of natural gas and air at low-load conditions. To aid understanding of the experimental data, chemical-kinetics simulations were carried out in a simplified engine-environment that provided insight into the chemical effects of methane (CH4) on pilot-fuel ignition. The simulations reveal that CH4 has an effect on both stages of n-heptane autoignition: the small, first-stage, cool-flame-type, low-temperature ignition (LTI) and the larger, second-stage, high-temperature ignition (HTI). As the ratio of pilot-fuel to CH4 entrained into the spray decreases, the initial oxidization of CH4 consumes the OH radicals produced by pilot-fuel decomposition during LTI, thereby inhibiting its progression to HTI. Using imaging diagnostics, the spatial and temporal progression of LTI and HTI in DF combustion are measured in a heavy-duty optical engine, and the imaging data are analyzed to understand the cause of severe fluctuations in ignition timing and combustion completeness at low-load conditions. Images of cool-flame and hydroxyl radical (OH*) chemiluminescence serve as indicators of LTI and HTI, respectively. The cycle-to-cycle and spatial variation in ignition extracted from the imaging data are used as key metrics of comparison. The imaging data indicate that the local concentration of the pilot-fuel and the richness of the surrounding natural-gas air mixture are important for LTI and HTI, but in different ways. In particular, higher injection pressures and shorter injection durations increase the mixing rate, leading to lower concentrations of pilot-fuel more quickly, which can inhibit HTI even as LTI remains relatively robust. Decreasing the injection pressure from 80 MPa to 40 MPa and increasing the injection duration from 500 µs to 760 µs maintained constant pilot-fuel mass, while promoting robust transition from LTI to HTI by effectively slowing the mixing rate. This allows enough residence time for the OH radicals, produced by the two-stage ignition chemistry of the pilot-fuel, to accelerate the transition from LTI to HTI before being consumed by CH4 oxidation. Thus from a practical perspective, for a premixed natural gas fuel–air equivalence-ratio, it is possible to improve the “stability” of the combustion process by solely manipulating the pilot-fuel injection parameters while maintaining constant mass of injected pilot-fuel. This allows for tailoring mixing trajectories to offset changes in fuel ignition chemistry, so as to promote a robust transition from LTI to HTI by changing the balance between the local concentration of the pilot-fuel and richness of the premixed natural gas and air. This could prove to be a valuable tool for combustion design to improve fuel efficiency or reduce noise or perhaps even reduce heat-transfer losses by locating early combustion away from in-cylinder walls.

Research Organization:
Sandia National Laboratories (SNL-CA), Livermore, CA (United States)
Sponsoring Organization:
USDOE Office of Energy Efficiency and Renewable Energy (EERE), Transportation Office. Vehicle Technologies Office; USDOE National Nuclear Security Administration (NNSA)
Grant/Contract Number:
AC04-94AL85000; NA0003525
OSTI ID:
1760366
Report Number(s):
SAND--2020-13341J; 692649
Journal Information:
International Journal of Engine Research, Journal Name: International Journal of Engine Research Journal Issue: 2 Vol. 23; ISSN 1468-0874
Publisher:
SAGECopyright Statement
Country of Publication:
United States
Language:
English

References (25)

Effects of pilot fuel quantity on the emissions characteristics of a CNG/diesel dual fuel engine with optimized pilot injection timing journal October 2013
A review of prechamber ignition systems as lean combustion technology for SI engines journal January 2018
N-heptane micro pilot assisted methane combustion in a Rapid Compression Expansion Machine journal September 2016
Experimental investigation of pilot-fuel combustion in dual-fuel engines, Part 1: Thermodynamic analysis of combustion phenomena journal November 2019
Experimental investigation of pilot-fuel combustion in dual-fuel engines, Part 2: Understanding the underlying mechanisms by means of optical diagnostics journal November 2019
Ignition of turbulent non-premixed flames journal February 2009
Conceptual models for partially premixed low-temperature diesel combustion journal April 2013
Kinetic modeling of gasoline surrogate components and mixtures under engine conditions journal January 2011
Understanding the ignition mechanism of high-pressure spray flames journal January 2017
Effect of methane on pilot-fuel auto-ignition in dual-fuel engines journal January 2019
Two-stage autoignition and edge flames in a high pressure turbulent jet journal July 2017
Characterization and Reduction of In-Use CH 4 Emissions from a Dual Fuel Marine Engine Using Wavelength Modulation Spectroscopy journal February 2019
Influence of Injection Parameters and Operating Conditions on Ignition and Combustion in Dual-Fuel Engines journal June 2018
Ignition of Diesel Pilot Fuel in Dual-Fuel Engines journal May 2019
Ignition, soot formation, and end-of-combustion transients in diesel combustion under high-EGR conditions journal June 2011
Characterization of reaction zone growth in an optically accessible heavy-duty diesel/methane dual-fuel engine journal February 2018
Flame Lift-Off on Direct-Injection Diesel Sprays Under Quiescent Conditions conference March 2001
Relationship Between Ignition Processes and the Lift-Off Length of Diesel Fuel Jets conference October 2005
An Investigation of Thermal Stratification in HCCI Engines Using Chemiluminescence Imaging conference April 2006
Development of an Experimental Database and Kinetic Models for Surrogate Diesel Fuels conference April 2007
End-of-Injection Over-Mixing and Unburned Hydrocarbon Emissions in Low-Temperature-Combustion Diesel Engines conference April 2007
Universal Rule of Hydrocarbon Oxidation conference April 2009
Experimental Study of Ignition and Combustion Characteristics of a Diesel Pilot Spray in a Lean Premixed Methane/Air Charge using a Rapid Compression Expansion Machine conference April 2012
Effect of Fueling Control Parameters on Combustion and Emissions Characteristics of Diesel-Ignited Methane Dual-Fuel Combustion conference April 2016
A Conceptual Model of DI Diesel Combustion Based on Laser-Sheet Imaging* conference February 1997

Similar Records

Influence of pilot-fuel mixing on the spatio-temporal progression of two-stage autoignition of diesel-sprays in low-reactivity ambient fuel-air mixture
Journal Article · Thu Nov 12 23:00:00 EST 2020 · Proceedings of the Combustion Institute · OSTI ID:1783249

Natural gas fueling of diesel engines
Journal Article · Thu Oct 31 23:00:00 EST 1996 · Automotive Engineering · OSTI ID:419467

Understanding the interplay between pilot fuel mixing and auto-ignition chemistry in hydrogen-enriched environment
Journal Article · Mon Jul 01 00:00:00 EDT 2024 · Proceedings of the Combustion Institute · OSTI ID:2404609