Selective laser melting of 304L stainless steel: Role of volumetric energy density on the microstructure, texture and mechanical properties
- Oregon State Univ., Corvallis, OR (United States); Advanced Technology and Manufacturing Institute (ATAMI), Corvallis, OR (United States); Oregon State University
- Oregon State Univ., Corvallis, OR (United States); Advanced Technology and Manufacturing Institute (ATAMI), Corvallis, OR (United States)
- Oregon State Univ., Corvallis, OR (United States)
The role of volumetric energy density on the microstructural evolution, texture and mechanical properties of 304L stainless steel parts additively manufactured via selective laser melting process is investigated. 304L is chosen because it is a potential candidate to be used as a matrix in a metal matrix composite with nanoparticles dispersion for energy and high temperature applications. The highest relative density of 99 %±0.5 was achieved using a volumetric energy density of 1400 J/mm3. Both XRD analysis and Scheil simulation revealed the presence of a small trace of the delta ferrite phase, due to rapid solidification within the austenitic matrix of 304L. Here, a fine cellular substructure ranged between 0.4–1.8 μm, was detected across different energy density values. At the highest energy density value, a strong texture in the direction of [100] was identified. At lower energy density values, multicomponent texture was found due to high nucleation rate and the existing defects. Yield strength, ultimate tensile strength, and microhardness of samples with a relative density of 99 % were measured to be 540 ± 15 MPa, 660 ± 20 MPa and 254 ± 7 HV, respectively and higher than mechanical properties of conventionally manufactured 304L stainless steel. Heat treatment of the laser melted 304L at 1200 °C for 2 h, resulted in the nucleation of recrystallized equiaxed grains followed by a decrease in microhardness value from 233 ± 3 HV to 208 ± 8 HV due to disappearance of cellular substructure.
- Research Organization:
- RAPID Manufacturing Institute (United States)
- Sponsoring Organization:
- USDOE Office of Energy Efficiency and Renewable Energy (EERE), Energy Efficiency Office. Advanced Manufacturing Office
- Grant/Contract Number:
- EE0007888
- OSTI ID:
- 1647744
- Journal Information:
- Additive Manufacturing, Journal Name: Additive Manufacturing Vol. 32; ISSN 2214-8604
- Publisher:
- ElsevierCopyright Statement
- Country of Publication:
- United States
- Language:
- English
Similar Records
Thermal stability of additively manufactured austenitic 304L ODS alloy
In Situ Neutron Diffraction Study of the Influence of Microstructure on the Mechanical Response of Additively Manufactured 304L Stainless Steel