Characterization of Creep-Fatigue Crack Growth in Alloy 709 and Prediction of Service Lives in Nuclear Reactor Components (Final Report)
- Univ. of Idaho, Moscow, ID (United States). Mechanical Engineering Dept.
- Idaho National Lab. (INL), Idaho Falls, ID (United States)
This final report summarizes the activities and results that were obtained by the research team working on the project “Characterization of Creep-Fatigue Crack Growth in Alloy 709 and Prediction of Service Lives in Nuclear Reactor Components”, DOE-NEUP Project 15-8623. This project was mainly concerned with the creep-fatigue crack growth characterization of austenitic stainless-steel Fe-20Cr-25Ni (Alloy 709). For this purpose, an array of experimental and computational activities was performed. The main goal of these activities was to describe and predict the crack growth behavior in Alloy 709 under different conditions of applied loading and temperature. Alloy 709 specimens were tested to describe both the uniaxial creep behavior and creep-fatigue crack growth rates at temperatures between 550°C and 700°C. Microstructure and fracture surface analysis was performed using several experimental techniques, and the defining features of crack growth propagation were identified and described. Thermodynamic and diffusion simulations were performed to understand the microstructure evolution of Alloy 709 at elevated temperatures, and to establish an aging schedule relevant for in-service conditions over extended periods. Experimental testing was performed on both as-received and aged Alloy 709 specimens. Two computational methods were developed to predict crack growth rates and remaining lives in specimens loaded under either fatigue of creep-fatigue. The first computational technique was the finite element method, while the second was strip-yield modeling. Both methods relied on the prediction of crack growth rates using the concept of plasticity-induced crack closure. Crack-tip opening loads were computed and used to perform crack growth rate predictions. The computational predictions matched well with the experimental results. The strip-yield model was shown to be an excellent predictive tool not only for crack growth in austenitic SS Alloy 709, but also in 316 SS, martensitic Cr-Mo steels, Ni-based alloys and Al-based alloys. The main conclusion of this study is that Alloy 709 exhibits excellent creep crack growth resistance at temperatures between 550°C and 700°C. In fact, the crack growth resistance of this alloy appears to be higher than that of 316 SS in similar testing conditions. Moreover, when creep loading with hold (dwell) times of 60s or 600s were intercalated every fatigue cycle, the crack growth rates did not change significantly. The conclusion is that the tests performed revealed that the crack growth is insignificant during the creep portion of a loading cycle, as compared with the crack growth during the fatigue portion of the cycle. In general, Alloy 709 shows excellent resistance to creep deformations and creep crack growth up to 700°C.
- Research Organization:
- Univ. of Idaho, Moscow, ID (United States)
- Sponsoring Organization:
- USDOE Office of Nuclear Energy (NE)
- DOE Contract Number:
- NE0008443
- OSTI ID:
- 1511029
- Report Number(s):
- DOE/NEUP-15-8623; 15-8623
- Country of Publication:
- United States
- Language:
- English
Similar Records
Experimental and computational studies of load ratio effect on fatigue crack growth rates in Alloy 709 at elevated temperatures
Environmentally assisted cracking in light water reactors annual report January - December 2005.