Skip to main content
U.S. Department of Energy
Office of Scientific and Technical Information

Determination of Grain Boundary Charging in Cu(In,Ga)Se2 Thin Films: Preprint

Conference ·
OSTI ID:1044452

Surface potential mapping of Cu(In,Ga)Se2 (CIGS) thin films using scanning Kelvin probe force microscopy (SKPFM) aims to understand the minority-carrier recombination at the grain boundaries (GBs) of this polycrystalline material by examining GB charging, which has resulted in a number of publications. However, the reported results are highly inconsistent. In this paper, we report on thepotential mapping by measuring wide-bandgap or high-Ga-content films and by using a complementary atomic force microscopy-based electrical technique of scanning capacitance microscopy (SCM). The results demonstrate consistent, positively charged GBs on our high-quality films with minimal surface defects/charges. The potential image taken on a low-quality film with a 1.2-eV bandgap showssignificantly degraded potential contrast on the GBs and degraded potential uniformity on grain surfaces, resulting from the surface defects/charges of the low-quality film. In contrast, the potential image on an improved high-quality film with the same wide bandgap shows significantly improved GB potential contrast and surface potential uniformity, indicating that the effect of surface defectsis critical when examining GB charging using surface potential data. In addition, we discuss the effect of the SKPFM setup on the validity of potential measurement, to exclude possible artifacts due to improper SKPFM setups. The SKPFM results were corroborated by using SCM measurements on the films with a CdS buffer layer. The SCM image shows clear GB contrast, indicating different electricalimpedance on the GB from the grain surface. Further, we found that the GB contrast disappeared when the CdS window layer was deposited after the CIGS film was exposed extensively to ambient, which was caused by the creation of CIGS surface defects by the ambient exposure.

Research Organization:
National Renewable Energy Laboratory (NREL), Golden, CO (United States)
Sponsoring Organization:
USDOE Office of Energy Efficiency and Renewable Energy (EERE), Solar Energy Technologies Office (EE-4S)
DOE Contract Number:
AC36-08GO28308
OSTI ID:
1044452
Report Number(s):
NREL/CP-5200-54111
Country of Publication:
United States
Language:
English

Similar Records

How Grain Boundaries in Cu(In,Ga)Se2 Thin Films are Charged: Revisit
Journal Article · Mon Jul 16 00:00:00 EDT 2012 · Applied Physics Letters · OSTI ID:1047927

Recent Progress in Nanoelectrical Characterizations of CdTe and Cu(In,Ga)Se2
Conference · Sun Nov 20 23:00:00 EST 2016 · Conference Record of the IEEE Photovoltaic Specialists Conference · OSTI ID:1343672

Nanometer-Scale Imaging of Inhomogeneous Active Charge Carriers in Arsenic-Doped CdTe Thin Films
Conference · Wed Feb 05 23:00:00 EST 2020 · OSTI ID:1604603