Optimized Baking of the DIII-D Vessel
The DIII-D tokamak vacuum vessel baking system is used to heat the vessel walls and internal hardware to an average temperature of 350 C to allow rapid conditioning of the vacuum surfaces. The system combines inductive heating and a circulating hot air system to provide rapid heating with temperature uniformity required by stress considerations. In recent years, the time to reach 350 C had increased from 9 hrs to 14 hrs. To understand and remedy this sluggish heating rate, an evaluation of the baking system was recently performed. The evaluation indicated that the mass of additional in-vessel hardware (50% increase in mass) was primarily responsible. This paper reports on this analysis and the results of the addition of an electric air heater and procedural changes that have been implemented. Preliminary results indicate that the time to 350 C has been decreased to 4.5 hours and the temperature uniformity has improved.
- Research Organization:
- General Atomics, San Diego, CA (US)
- Sponsoring Organization:
- US Department of Energy (US)
- DOE Contract Number:
- AC03-99ER54463
- OSTI ID:
- 766801
- Report Number(s):
- GA-A23274; TRN: US0109390
- Resource Relation:
- Conference: 18th IEEE/NPSS Symposium on Fusion Engineering, Albuquerque, NM (US), 10/25/1999--10/29/1999; Other Information: PBD: 1 Nov 1999
- Country of Publication:
- United States
- Language:
- English
Similar Records
Baking of the vacuum vessel prototype of the Spanish stellarator with a control system based on neural network
Design and analysis of the DIII-D vacuum vessel