Joining techniques for a reduced activation 12Cr steel for inertial fusion energy
At Lawrence Livermore National Laboratory, we are developing a reduced activation ferritic martensitic steel that is based on the ferritic martensitic steel HT-9. As a part of the development of this steel, we tested a series of welding processes for characterization, including conventional welds (electron beam, tungsten inert gas, and laser) as well as solid-state welds (hot isostatic pressing). We also heat treated the joints at various temperatures between 750 °C and 1050 °C to find a suitable normalization scheme. The modified HT-9 reduced activation ferritic martensitic steel appears highly suitable to welding and diffusion bonding. All welds showed good quality fusion zones with insignificant cracking or porosity. Additionally, a heat treatment schedule of 950 °C for one hour caused minimal grain growth while still converging the hardness of the base metal with that of the fusion and heat-affected zones. Also, modified HT-9 diffusion bonds that were created at temperatures of at least 950 °C for two hours at 103 MPa had interface tensile strengths of greater than 600 MPa. The diffusion bonds showed no evidence of increased hardness nor void formation at the diffusion bonded interface.
- Research Organization:
- Lawrence Livermore National Lab. (LLNL), Livermore, CA (United States)
- Sponsoring Organization:
- USDOE
- DOE Contract Number:
- DE-AC52-07NA27344
- OSTI ID:
- 1165758
- Journal Information:
- Fusion Engineering and Design, Vol. 89, Issue 7-8; ISSN 0920-3796
- Publisher:
- Elsevier
- Country of Publication:
- United States
- Language:
- English
Similar Records
Microstructural characterization of autogenous GTA welds in a 12Cr-1Mo-0. 3V steel
Review of Dissimilar Metal Welding for the NGNP Helical-Coil Steam Generator