Tensile deformation behavior of spray-deposited FVS0812 heat-resistant aluminum alloy sheet at elevated temperatures
- College of Materials Science and Engineering, Hunan University, Changsha 410082 (China)
The tensile deformation behavior of spray deposited FVS0812 heat-resistant aluminum alloy sheet was studied by uniaxial tension tests at temperatures ranging from 250 deg. C to 450 deg. C and strain rates from 0.001 to 0.1 s{sup -1}. The associated fracture surfaces were examined by scanning electron microscopy (SEM). The results show that the degree of work-hardening increases with decreasing temperature, and exhibits a small decrease with increasing strain rate; the strain rate sensitivity exponent increases with increasing temperature. The flow stress increases with increasing strain rate but decreases with increasing temperature. The total elongations to fracture increase not only with increasing temperature, but also with increasing strain rate, which is in marked contrast with the normal inverse dependence of elongation on the strain rate exhibited by conventional aluminum alloy sheets. The SEM fracture analysis indicates that the dependence of elongation on the strain rate may be due to the presence of a transition from plastic instability at lower strain rates to stable deformation at higher strain rates for fine-grained materials produced by spray deposition.
- OSTI ID:
- 21003565
- Journal Information:
- Materials Characterization, Vol. 58, Issue 6; Other Information: DOI: 10.1016/j.matchar.2006.06.024; PII: S1044-5803(06)00220-8; Copyright (c) 2006 Elsevier Science B.V., Amsterdam, The Netherlands, All rights reserved; Country of input: International Atomic Energy Agency (IAEA); ISSN 1044-5803
- Country of Publication:
- United States
- Language:
- English
Similar Records
Experimental investigation of anisotropy evolution of AZ31 magnesium alloy sheets under tensile loading
Tensile properties of bare-rolled ingot-sheet beryllium from room temperature to 800$sup 0$C