Heat-resistant, electrically conducting joint between ceramic end plates and metallic conductors in solid oxide fuel cell
Ceramic parts made of doped lanthanum chromite are used as interconnects and end plates in stacks for several solid oxide fuel cell (SOFC) designs. Metallic conductors have to be attached to enable a low-resistance connection between individual stacks in each SOFC unit and to permit power to be drawn from the SOFC. The resistances of the metal-ceramic bond and the metallic conductors have to be stable under operating conditions, i.e., 1,000 C in air. Consequently, heat-resistant materials have to be used. A two-step process has been developed to connect commercially available, Ni- or Fe-based metallic conductors to ceramic SOFC end plates by vacuum furnace brazing. In the first step, a metallic sheet, which acts as the current collector, is brazed onto the ceramic end plate. Thereby, the much lower electrical conductivity of the ceramic part is compensated by that of the metal. The chromium alloy CrFe5Y{sub 2}O{sub 3}1 is suitable because it is heat-resistant, and its thermal expansion coefficient is close to that of lanthanum chromite. In the second step, metallic wires or strips are brazed on the current collector. Since this joint area is significantly smaller than that of the first joint, materials with a different thermal expansion coefficient can be used, such as conventional heat-resistant nickel alloys (Inconel 617) and ferritic stainless steels (FeCrAl 25 5). Filler alloys for both brazing steps with matching melting points have been found. Hence, both brazing steps can be performed cost-effectively in one heating step. Suitable parameters for vacuum furnace brazing of both joints are presented, and the composition of the filler alloys is given. Data concerning the long-term behavior of the joint resistances in air at 1,000 C are discussed.
- Research Organization:
- Forschungszentrum Juelich GmbH (DE)
- OSTI ID:
- 20086893
- Resource Relation:
- Conference: 1999 Materials Research Society Spring Meeting, San Francisco, CA (US), 04/05/1999--04/08/1999; Other Information: PBD: 2000; Related Information: In: New materials for batteries and fuel cells. Materials Research Society symposium proceedings, Volume 575, by Doughty, D.H.; Nazar, L.F.; Arakawa, Masayasu; Brack, H.P.; Naoi, Katsuhiko [eds.], 454 pages.
- Country of Publication:
- United States
- Language:
- English
Similar Records
Mechanical design of ceramic beam tube braze joints for NOvA kicker magnets
Durable, Impermeable Brazes for Solid Oxide Fuel Cells (Final Report)