skip to main content
OSTI.GOV title logo U.S. Department of Energy
Office of Scientific and Technical Information

Title: Treatment of nitrocellulose by thermal decomposition

Conference ·
OSTI ID:20014773

Waste fines generated during the manufacture of nitrocellulose (NC) are classified as a RCRA K044 hazardous waste due to their explosive properties. The objective of this study was to evaluate controlled thermal treatment of NC in order to render it nonhazardous and allow for more economical ultimate disposal. The results indicate that controlled thermal decomposition at 130--150 C is a technically feasible process. Rates improved significantly at higher temperatures. At 150 C, only 10 hours were needed to reduce the nitrogen content of NC from 13.7% to below 10% (versus 105 h at 130 C), a level found in many commercial, nonhazardous grades of NC. The air flow rate over the heated NC, and the moisture content of the NC or air above it had no discernible effect on rates of nitrogen removal. Greater mass loss from the NC than what was attributable to the nitro groups alone indicated that decomposition of the polymer backbone also occurred. This was confirmed by FTIR analyses, the appearance of CO{sub 2} in the off-gas, and a lack of correlation between percent nitrogen and heat of combustion. Samples of thermally treated NC containing 9.7% nitrogen failed three of the basic tests used by the Bureau of Explosives to ascertain explosive characteristics, indicating that the product was no longer hazardous based on its energetic properties. Although technically feasible, use of thermal decomposition to treat NC fines will most likely be restricted by safety concerns. Operating close to 130 C would mitigate the risk, but considerably extends the time required for treatment. The most suitable application of this technology may instead by treatment of NC-contaminated soils.

Research Organization:
Environmental Protection, Davis-Monthan AFB, AZ (US)
OSTI ID:
20014773
Resource Relation:
Conference: ASCE-CSCE 1999 National Conference on Environmental Engineering, Norfolk, VA (US), 07/25/1999--07/28/1999; Other Information: PBD: 1999; Related Information: In: Environmental engineering 1999, by Schafran, G.C. [ed.], 936 pages.
Country of Publication:
United States
Language:
English