90 Search Results

Advances in time and space resolved measurements of highly charged states of tungsten (W) through x-ray imaging spectroscopy have enabled investigation of impurity transport in the Wendelstein 7-X (W7-X) stellarator. The high-resolution x-ray imaging spectrometer (HR-XIS) system on W7-X utilizes the Bragg diffraction properties of a set of multiple crystals to measure a range of impurity emission lines within sections of the 1–7 Å wavelength range, including transitions of W. A new indium–antimonide crystal has been installed on the HR-XIS system to allow viewing of the 5.5–6.2 Å region focusing on emissions of W. Consequently, many bright W emission linesmore » from W⁴⁰⁺ to W⁴⁷⁺ were observed in this wavelength range, both in plasmas with injected W and in those with only intrinsic W impurity sources, showing the high sensitivity of the diagnostic. Three W⁴⁶⁺ emissions correspond in wavelength and intensity with calculated photon emissivity coefficients and can be exploited for W transport and concentration applications in plasmas with T_e ≳ 2.1 keV. Here, an estimate of the core W density behavior in two separate turbulence-reduced ‘high-performance’ (HP) discharges on W7-X is done using the 5.6893 Å W⁴⁶⁺ line. The n_W behavior in HP scenarios can be explained by previous experimental results and neoclassical predictions.« less

Amine-functionalized solid sorbents are a class of sorbent materials proposed for direct air capture (DAC) of CO₂, yet their long-term performance is susceptible to degradation under realistic operating conditions. Many amines are not thermodynamically stable in air, and amine sorbents oxidize while in use during DAC temperature swing adsorption processes. In this study, we investigate the role of transition metal ion contaminants, specifically Cu²⁺, Fe²⁺, and Ni²⁺, on the oxidative degradation of poly(ethylenimine) (PEI)-impregnated SBA-15 sorbents. By introducing metal ions via different modes mimicking both synthesis-related impurities and impurities derived from environmental exposure, we systematically evaluate sorbent stability after exposuremore » to dry air at an elevated temperature. Thermogravimetric CO₂ uptake measurements reveal that even trace levels of Cu and Fe (as low as ∼4 ppm) can lead to measurable sorbent deactivation after oxidative aging, despite negligible loss in the performance of the control samples. In situ infrared, UV–vis, and X-ray photoelectron spectroscopies indicate that these metals catalyze radical-driven oxidation pathways, altering the chemical structure of the sorbent and accelerating degradation. Our findings underscore the need to account for trace metal contamination during DAC sorbent synthesis and deployment and highlight the importance of environmental contamination pathways.« less

Transition-metal oxyhydroxides such as CoOOH are promising low-cost electrocatalysts for the selective electrooxidation of organic molecules, yet the influence of ubiquitous transition-metal impurities on their performance and durability remains poorly understood. Here, we experimentally probed the individual and synergistic electrochemical and structural effects of Ni and Mn incorporations into model CoOOH electrocatalysts toward an efficient benzyl alcohol oxidation reaction (BAOR). Comprehensive electrochemical, microscopic, and spectroscopic analyses reveal that Ni incorporation enhances charge-transfer kinetics and overall activity through the formation of catalytically active Ni³⁺ sites, whereas Mn exhibited a more complex but interesting role. At the early stages of operation, Mn⁴⁺more » acts as a stabilizing surface layer that mitigates catalyst degradation but partially blocks Co sites before they undergo gradual leaching. The concurrent incorporation of both Ni and Mn yields a trimetallic 2NMC@NF electrocatalyst that integrates the activity benefits of Ni with the stability conferred by Mn, achieving 92.9% benzyl alcohol conversion and 91.4% Faradaic efficiency after 24 h at 1.5 V vs RHE. These findings elucidate how trace Ni and Mn impurities, often introduced from electrolytes or external sources, can modulate the lattice and electronic structure of CoOOH, offering a design strategy for enhancing both activity and long-term stability in electrocatalytic organic oxidation.« less

Achieving self-consistent performance predictions for ITER requires integrated modeling of core transport and divertor power exhaust under realistic impurity conditions. We present results from a systematic power-flow and impurity-content study for the ITER 15 MA baseline scenario constrained directly by existing SOLPS-ITER neon-seeded divertor solutions. Using the OMFIT STEP workflow, stationary temperature and density profiles are predicted with TGYRO for $$1.5 \unicode{x2A7D} Z_\textrm{eff} \unicode{x2A7D} 2.5$$, and the corresponding power crossing the separatrix $$P_\textrm{sep}$$ is evaluated. We find that $$P_\textrm{sep}$$ varies by more than a factor of 1.7 across this scan and matches the $${\sim}100$$ MW SOLPS-ITER prediction when $$Z_\textrm{eff} \simeqmore » 1.6$$ or when auxiliary heating is reduced to $${\sim}75\%$$ of nominal. Rotation-sensitivity studies show that plausible variations in toroidal flow magnitude modify $$P_\textrm{sep}$$ by $$\lesssim 20\%$$, while AURORA modeling confirms that charge-exchange radiation inside the separatrix is dynamically negligible under predicted ITER neutral densities. These results identify a restricted compatibility window, $$Z_\textrm{eff} \approx 1.6$$ –1.75 and $$0.75 \lesssim f_{P_\textrm{aux}} \unicode{x2A7D} 1.0$$, in which core transport predictions remain aligned with neon-seeded divertor protection targets. This self-consistent, model-constrained framework provides actionable guidance for impurity control and auxiliary-heating scheduling in early ITER operation and supports future whole-device scenario optimization.« less

Dopants in semiconductor nanostructures offer tremendous control over electronic, optical, and magnetic properties beyond what is achievable in bulk materials. We demonstrate that the broad dopant emission in semiconductor nanoplatelets effectively maps the electron wave function across the nanoplatelet thickness. Both the emission energy and lifetime of the dopant transition depend strongly on the depth of the dopant within the nanoplatelet. This dependence arises from the electrostatic self-interaction of the charged dopant, which varies with proximity to the dielectric discontinuity at the nanoplatelet surface. Through comprehensive single-particle spectroscopy of silver-doped CdSe nanoplatelets, we verify that acceptors near the center emitmore » at higher energies with shorter lifetimes, while those near the surface emit at lower energies with longer lifetimes. This spatial mapping also reveals unusual two-color emission from individual nanoplatelets, with enhanced Auger recombination yielding exceptional photon antibunching (>90% purity) at room temperature, suggesting potential applications in quantum information technologies.« less

Suspended solids can be the primary vector for transporting contaminants in streams. The objective of this study was to determine whether changes in the properties of suspended solids during rain events impacted contaminant transport. Stream water was collected during five episodic events downstream from a U-contaminated wetland located in South Carolina, USA. The suspended particles were initially composed of Fe-flocs (particles formed in situ prior to the rain event) that had significantly greater Fe, Mn, organic-C, and U content than particles collected later during a sampling rain event. XANES and EXAFS revealed that U in the Fe-flocs was U(VI) andmore » that it was not incorporated in a mineral structure but existed as inner- or outer-sphere adsorbed uranyl species associated with organic matter and Fe-oxides. The uranyl had an extraordinarily high affinity for the suspended solids, with solid to liquid U ratios of >72,000 (μg/kg)/(μg/L). After the initial flush of Fe-flocs, a greater fraction of the suspended solids had lower organic-C, Fe, Mn, and amorphous phases and were composed of more quartz, kaolinite, and gibbsite, resulting in lower U concentrations than those in the solids collected earlier in the rain event. This study highlights the importance of understanding suspended solids as transport vectors and their potential dynamic nature during rain events.« less

Graphene nanoribbons (GNRs) are quantum-confined π-conjugated monolayer semiconductors with attractive properties for optoelectronic applications. However, the ground- and excited-state properties of charge carriers in GNRs are still poorly understood, particularly with regards to the coupling between charges and the GNR lattice and the degree to which this coupling impacts local and macroscopic charge transport. To address this issue, we systematically correlate carrier density-dependent charge transport with spectroscopic modulations in chemically doped thin films of armchair graphene nanoribbons (9-aGNRs). This study combines Fourier transform infrared (FTIR) and ultraviolet−visible−near-infrared (UV−vis−NIR) spectroscopy with both local and macroscopic conductivity measurements to arrive at amore » full and self-consistent picture of transport in doped GNR thin films. Using three different molecular p-type dopants (i.e., oxidants), we demonstrate that hole polarons are the dominant quasi-particle determining charge transport in GNRs and that the degree of polaron delocalization depends sensitively on the dopant and the hole density. For all three dopants, the local conductivity probed by microwave spectroscopy substantially exceeds the long-range conductivity obtained by four-point probe measurements. Interestingly, the dopant size substantially influences charge transport at high hole densities. We ascribe this effect to different propensities for forming bipolarons with lower mobilities than polarons. Comparison of GNR transport and spectral properties to other prototypical π-conjugated semiconductors (e.g., semiconducting polymers or carbon nanotubes) benchmark the charge transport properties of GNR thin films for optoelectronic devices and applications.« less

Thousands of chemical contaminants threaten watersheds but are time and cost prohibitive to monitor. Identifying their sources, transport, and ecological risk is limited in heterogeneous urban watersheds. We present an integrative watershed approach using source-specific indicator compounds, common water quality measures, and ecotoxicity assays to examine the distribution of contaminant mixtures in an urbanized watershed. Indicator compound concentrations were temporally and spatially distributed for treated/untreated sewage (sucralose, artificial sweetener), road runoff (diphenyl-guanidine [DPG] and 6PPD-quinone [6PPD-Q], automobile tire additives), and lawncare runoff (aminomethanephosphonic acid (AMPA), major degradant of the herbicide glyphosate). Sucralose was predominately sourced from treated wastewater; measurable concentrationsmore » in tributaries indicated raw sewage inputs. DPG and 6PPD-Q concentrations correlated to road density during base flow and were elevated during stormflow. AMPA was measurable spring through fall, especially where lawns were dense. When specific sources dominated flow, water quality measures correlated with wastewater (sulfate, potassium, chloride, and sodium) and road runoff (chromium and lead) indicators. The limited behavioral toxicity observed in exposed zebrafish (Danio rerio) (18%) was not well explained by source-indicators. PFAS concentrations were highly variable spatially but not well explained by our source-specific indicator compounds. Here, more costly compound-specific monitoring may be necessary when multiple sources exist or when unexpected toxicity trends occur.« less

Abstract Plasma-impurity reaction rates are a crucial part of modelling tokamak scrape-off layer (SOL) plasmas. To avoid calculating the full set of rates for the large number of important processes involved, a set of effective rates are typically derived which assume Maxwellian electrons. However, non-local parallel electron transport may result in non-Maxwellian electrons, particularly close to divertor targets. Here, the validity of using Maxwellian-averaged rates in this context is investigated by computing the full set of rate equations for a fixed plasma background from kinetic and fluid SOL simulations. We consider the effect of the electron distribution as well asmore » the impact of the electron transport model on plasma profiles. Results are presented for lithium, beryllium, carbon, nitrogen, neon and argon. It is found that electron distributions with enhanced high-energy tails can result in significant modifications to the ionisation balance and radiative power loss rates from excitation, on the order of 50%–75% for the latter. Fluid electron models with Spitzer-Härm or flux-limited Spitzer-Härm thermal conductivity, combined with Maxwellian electrons for rate calculations, can increase or decrease this error, depending on the impurity species and plasma conditions. Based on these results, we also discuss some approaches to experimentally observing non-local electron transport in SOL plasmas.« less

Understanding the interfacial evolution of alloys in molten salt with different amounts of water (H₂O) and oxygen (O₂) impurities is significant for applications in many fields, including concentrated solar power, molten salt reactors, and applications in pyrochemical reprocessing and electrorefining. Additionally, the impurity-driven corrosion mechanisms that lead to various morphological and chemical evolution characteristics at the interfaces of structural alloys and molten salts are not fully understood. In the present work, the three-dimensional (3D) morphological evolution of Ni-20Cr microwires in LiCl-KCl was studied at 500 °C under different moisture and oxygen conditions using in situ synchrotron transmission X-ray microscopy (TXM)more » and scanning transmission electron microscopy (STEM) techniques. No significant morphological changes were observed in Ni-20Cr microwires under vacuum conditions. However, the wires exhibited distinct morphological evolutions when exposed to molten salt containing H₂O alone, as well as when both H₂O and O₂ were present. Furthermore, Cr₂O₃ precipitates were observed in the molten salt during corrosion with only H₂O present, while Cr⁶⁺ species were identified in the salt when O₂ was added. Further, these findings are crucial for understanding the corrosion mechanisms of molten salt with different amounts of H₂O and O₂ contamination, providing insights for developing corrosion mitigation methods and improving the stability of containment alloys in molten salt applications.« less