79 Search Results

The enhanced radiolytic stability of gibbsite (α-Al(OH)₃) containing trace nitrate (NO₃⁻) is a phenomenon in nuclear waste management, but its structural origins remain unresolved. Motivated by the detection of minority tetrahedral aluminum (T_d) defects in synthetic gibbsite, we hypothesized that these sites may participate in NO₃⁻ retention or mediate H₂ suppression. To evaluate this, we combined orthogonal techniques comprised of spatially selective solid-state ²⁷Al MAS NMR, comparative spectroscopy, and density functional theory (DFT) modeling. Paramagnetic editing and dynamic nuclear polarization (DNP) MAS NMR confirm that T_d defects are confined to the particle interior. DFT calculations reveal no energetic stabilization ofmore » NO₃⁻ near T_d sites. Comparative NMR analysis shows that T_d is also present in chloride-bearing gibbsite, which exhibits high radiolytic hydrogen yields. These three independent disqualifications rule out T_d as a structural contributor to nitrate-mediated suppression and narrow the scope of defect-driven explanations. The findings redirect mechanistic attention away from coordination defects and toward redox-active impurity pathways, providing a refined foundation for understanding radiation tolerance in Al(OH)₃.« less

Defect accumulation and microstructural evolution during ion irradiation at elevated temperatures are governed by competing processes of defect production, driven by the dose rate, and defect recovery, controlled by diffusion, interaction, and annihilation. Here, this study investigates the effects of irradiation temperature and the dose rate on microstructural evolution, deuterium retention, and lithium volatilization in γ-LiAlO₂ pellets subjected to sequential He⁺ and D⁺ ion irradiation. Experiments were performed to a total fluence of 3 × 10¹⁷ (He⁺ + D⁺)/cm² at 623, 673, 723, and 773 K with an average He⁺ dose rate of 7.7 × 10⁻⁴ dpa/s, and to 2more » × 10¹⁷ (He⁺ + D⁺)/cm² at 773 K with dose rates of 6.8 × 10⁻⁵, 2.9 × 10⁻⁴, and 7.3 × 10⁻⁴ dpa/s. At 623 K, the microstructure was dominated by cavities and fractures with no observable precipitate formation, while small precipitates emerged at 673 K. Increasing the irradiation temperature to 723–773 K promoted the formation of larger, faceted LiAl₅O₈ precipitates, and surface amorphization, accompanied by pronounced lithium depletion and H–D isotopic exchange. At 773 K, medium and high dose rates produced an amorphized surface layer over a crystalline subsurface containing LiAl₅O₈ precipitates and blisters at the crystalline–amorphous interface, whereas low-dose-rate irradiation preserved surface crystallinity with cavities distributed in the matrix, around precipitates, and along grain boundaries. Precipitate morphology was anisotropic with limited size dependence on the dose rate. These results elucidate the coupled effects of temperature and the dose rate and demonstrate that sequential He⁺ and D₂⁺ irradiation at 773 K reproduces key microstructural features and H isotope behavior observed in neutron-irradiated γ-LiAlO₂ at 573 K.« less

High-resolution mobility-based ion separations in Structures for Lossless Ion Manipulations (SLIM) have been useful for ion mobility separations for a variety of molecular classes in the gas phase. Here, in this study, we present multipass SLIM separations for gas-phase proteins in their near-native state exhibiting charge-state-dependent arrival time distributions using carbonic anhydrase (29 kDa), alcohol dehydrogenase (148 kDa), and apo-transferrin (79 kDa). The experimental CCS values were obtained from calibration curves for the arrival times of Agilent Tune Mix ions. For multipass separations, the ATDs were converted to CCS values by deconvoluting the multipass arrival times into accurate single-pass valuesmore » amenable to the single-pass calibration curves. Mass spectra of carbonic anhydrase (CA) showed three different charge states (z = 9+ to 11+). Their corresponding mobility peaks were baseline-separated by using 8-m single-pass separations. When compared to the corresponding drift tube ion mobility (DTIMS) measurements, the CCS values obtained from DTIMS and SLIM were in agreement within experimental error. Single-pass analysis of alcohol dehydrogenase (ADH) exhibits three predominant charge states (z = 23+ to 25+) with mobility overlap between adjacent charge states. The mobility peak resolution for ADH improved with multipass separations (up to 24-m path length). In addition, CCS distributions obtained for charge states z = 16+ to 18+ of apo-transferrin reveal a transition from a compact unimodal form (z = 18+ and 19+) to broader multimodal CCS distributions for z = 16+. For apo-transferrin, 40-m multipass separations were performed allowing for complete isolation of the selected mobility range corresponding to z = 17+, leading to selective isolation of a narrow arrival time window. The extended mobility separations provided minimal alterations to the structure of the proteins, and the experimentally derived CCS values showed minimal change as a function of the separation time or number of passes. Mobility-based ion separations for native-like proteins, using SLIM, open opportunities for native-IMS applications as well as other manipulations enabled by SLIM-like mobility-selective isolation and collection.« less

Oriented attachment is a critical, yet poorly understood, crystal growth pathway based on the self-assembly of nanocrystals. During oriented attachment, solvent-separated particles align and coalesce through forces that enable precise rotation and translation. While prior studies emphasized intragap forces driving crystallographic alignment, the forces enabling uniform stacking and superlattice formation remain unclear. Here, we demonstrate how macroscopic gibbsite mesocrystals emerge from nanoplates guided into staggered positions by directional sliding. Electron microscopy and X-ray scattering reveal the monoclinic superlattice structure, based on nanoplate stacking with a uniform ≈50° stagger along the gibbsite [010] direction. In situ liquid-cell TEM captures preferential slidingmore » along the gibbsite [010] direction, decelerating with increasing particle overlap. Molecular dynamics simulations reveal that this staggered arrangement corresponds to a global free-energy minimum, rather than full alignment. The simulations also confirm that sliding along the [010] direction is energetically favored and provide insight into the role of interfacial water in achieving long-range ordered assemblies. These insights highlight the energy landscape’s role in oriented attachment, with implications for material synthesis and hierarchical structures in nature.« less

We analyzed the hydroxyl librational signatures of five structurally related aluminum (oxy)hydroxides, using inelastic neutron scattering (INS) and plane-wave lattice dynamics simulations. A clear trend across these aluminum-containing phases illustrates the relationship between hydrogen bonding, local atomic structure, and the spectral location and profile of the librational bands. The INS spectra have been compared to previous optical spectroscopy and computational studies, highlighting the complementary nature of the INS technique. Taking into account other structurally or chemically related material analogs, we have identified a correlation between a blueshift (to higher energy) of the upper librational band edge and the geometry ofmore » the hydrogen bond interactions, mirroring (with opposite correlation) the well-known redshift in the intramolecular O–H stretching energy with increasing hydrogen bond strength. For hydroxyl groups that do not participate in hydrogen bonding effectively, the bending librations occur at lower energies and hybridize with metal–oxygen lattice modes. Standard density functional theory approximations, including dispersion corrections, struggle to correctly predict vibrational frequencies of motions dominated by H but perform well for metal–oxygen modes, allowing us to make detailed mode assignments in several cases, including a demonstration of how layer-to-layer disorder in boehmite hydrogen bond orientations is reflected in the sharp but minor low energy peaks (at ∼70–80 meV) of the INS spectrum.« less

Gibbsite (α-Al(OH)₃, sometimes designated as γ-Al(OH)₃) plays a crucial role in the chemistry of aluminum in the environment and industry, yet its crystallization behavior under multianionic conditions is not well understood. Here, in this study, we investigate how six common anions─fluoride (F^–), chloride (Cl^–), bromide (Br^–), nitrate (NO₃^–), sulfate (SO₄^2–), and phosphate (PO₄^3–)─influence the mineralization, structure, and morphology of gibbsite at room temperature. The results show that PO₄^3–, SO₄^2–, and F^– strongly inhibit gibbsite formation, stabilizing amorphous or alternative crystalline phases such as nordstrandite and cryolite. On the contrary, Cl^–, Br^–, and NO₃^– allow partial to complete crystallization of gibbsitemore » without significant morphological changes. Solid-state ²⁷Al magic angle spinning nuclear magnetic resonance provides crucial insight into aluminum coordination environments in both crystalline and amorphous phases, distinguishing between octahedral, pentahedral, and tetrahedral Al species. The density functional theory calculations reveal a direct correlation between the Al–X bond strength and the inhibition of crystallization, following the order: PO₄^3– > SO₄^2– > F^– > NO₃^– > Cl^– > Br^–. These findings offer molecular-scale insights into anion-specific effects on aluminum hydroxide nucleation and transformation, improving the understanding of gibbsite formation and aluminum cycling in soils, phosphate retention, contaminant immobilization, and waste treatment strategies in nuclear and industrial settings. These insights can also guide the controlled synthesis of aluminum hydroxide materials with tailored crystallinity and morphology via liquid-assisted methods.« less

Mineral dissolution is typically thought to occur by the detachment of monomeric building blocks of the crystal structure, although direct evidence is rare. Using in situ high-speed atomic force microscopy to examine step-edge retreat dynamics at high resolution, we report that the dissolution of gibbsite in alkaline solutions occurs mainly by the release of aluminate dimers, which subsequently dissociate into the monomeric species that dominate the solution. Here, the observed dissolution anisotropy is readily explained by this mechanism, which was further supported by density functional tight-binding simulations of detachment activation energies. Recognition that such polynuclear dissolution mechanisms exist may enablemore » an improved understanding of processes regulating mineral dissolution rates in nature and industry.« less

Understanding rare‐earth element (REE) mineralization mechanisms is essential for developing efficient separation strategies. Although the geochemical pathways that generate REE deposits are qualitatively known, quantitative links between specific conditions and mineralization outcomes remain limited. Herein, the repurpose laboratory REE hydrothermal synthesis data—originally collected for functional‐materials fabrication—as a surrogate for studying mineralization with data‐driven methods. The compiled 1,200+ hydrothermal reaction records and trained three machine‐learning models—K‐nearest neighbors (KNN), random forest (RF), and extreme gradient boosting (XGB)—to predict product elements and phases from precursors, additives, reaction conditions, and engineered features. Validation shows XGB achieves the highest accuracy. Feature importance indicates thermodynamic propertiesmore » of cations and anions dominate model decisions. Correlations reveal positive relationships among precursor concentration, reaction time, pH, and temperature, consistent with classical crystallization behavior. XGB‐based regressors are built to predict crystallization temperature and pH from precursor/product attributes. Performance is strongest when similar training examples exist, while accuracy declines for underrepresented reactions, notably REE carbonates and heavy‐REE systems. Overall, the study shows that functional‐materials datasets can illuminate REE mineralization and provide priors for exploration and processing. Expanding datasets with less‐studied chemistries and conditions will improve generality and support deposit discovery and more efficient REE recovery.« less

Gibbsite (aluminum hydroxide, Al(OH)₃) nanoparticles, synthesized from aluminum chloride or aluminum nitrate, were doped with metal ions, Cr(III) or Fe(III), and then irradiated with γ rays to determine the effect of the dopants on radiolytic hydrogen (H₂) production and radical generation. The addition of Cr(III) and Fe(III) ions at concentrations of 0.5% or 5% decreased the concentration of stable oxygen-centered radicals, with the strongest suppression in Cr(III) doped samples. A decrease in H₂ yields was observed with increasing Cr(III) or Fe(III) concentrations, with the greatest effect observed for the Fe(III)-doped samples. Reduction of the Cr(III) to Cr(II) and Fe(III) tomore » Fe(II) was also observed, probably due to scavenging of radiolytically produced electrons. However, further processes differ for Fe(III)- and Cr(III)-doped systems. Both ions are reduced by the free electrons, leading to a decrease in H₂ production, but they react differently with the oxygen radicals. Cr(III) can be oxidized by oxygen radicals, whereas Fe(III) cannot. Fe(II) can interact with peroxides, possible products of intermediate oxygen oxidation, converting back to Fe(III) and leaving oxygen radicals behind. These oxidation reactions lead to a difference in the observed relative effects on H₂ yields and oxygen radical production between Cr(III)- and Fe(III)-doped gibbsite. In conclusion, the connection between electron scavenging and H₂ production indicates that radiolytically produced electrons are precursors to H₂.« less

Although heterogeneous photo‐Fenton reactions on nanoparticulate iron oxides effectively degrade organic pollutants, the underlying surface mechanisms remain debated. Here, we demonstrate how these pathways are modulated by specific hematite crystal facets. To investigate the influence of particle surface structure, methylene blue (MB) adsorption and photodegradation kinetics are examined using facet‐engineered hematite nanoparticles with distinct exposed facets. The results reveal that MB photodegradation strongly depends on both pH and facet orientation. When normalized by surface area, (116) facet shows higher photodegradation activity than those with (104) or (001) facets. This enhanced activity is attributed to favorable electronic structure and surface characteristics,more » including a smaller optical bandgap, faster charge transfer, and superior H₂O₂ decomposition. In contrast, the photodegradation capacity follows (104) 〉 (116) 〉 (001), primarily due to the higher density of surface‐active sites on the (104) facet. These sites promote coupled MB adsorption and degradation, enabling removal of a greater overall quantity of MB. Additionally, under high pH conditions, hematite can degrade MB in the dark, with capacities following (001) ≫ (116) 〉 (104). These findings underscore the critical catalytic role of specific hematite surfaces and advance the understanding of facet‐dependent photoinduced redox chemistry at mineral–water interfaces.« less