Utah FORGE Friction-Permeability-Seismicity Laboratory Experiments with Non-Linear Acoustics

Eijsink, Agathe; Elsworth, Derek

doi:10.15121/1879451

Title: Utah FORGE Friction-Permeability-Seismicity Laboratory Experiments with Non-Linear Acoustics

Dataset
Other Related Research

Abstract

Laboratory experimental data on saw-cut interface of Westerly Granite and Utah Forge granitoid rocks. Experiments include velocity-stepping and fluid pressure stepping experiments. Mechanical data from 3 ISCO pumps connected to a Temco pressure vessel measure axial, confining and fault: fluid pressure (kPa), fluid flow rate (mL/min) and volume remaining in pump (mL). Non-linear acoustic data acquired via Verasonics systems connected to PZTs inside the pressure vessel give the timeshift, amplitude and RMS amplitude of the passing P-wave.

Authors:

Eijsink, Agathe; Elsworth, Derek

Penn State University

Publication Date:: Fri Jul 08 04:00:00 UTC 2022

Other Number(s):: 1400

DOE Contract Number:: EE0007080

Research Org.:: DOE Geothermal Data Repository; Penn State University

Sponsoring Org.:: USDOE Office of Energy Efficiency and Renewable Energy (EERE), Renewable Power Office. Geothermal Technologies Program (EE-4G)

Collaborations:: Penn State University

Subject:: 15 GEOTHERMAL ENERGY; Utah; Utah FORGE; acoustic data; acoustics; failure; fault permeability; friction experiments; geothermal; nonlinear acoustics; pressure; raw data; step test; test; testing; velocity

OSTI Identifier:: 1879451

DOI:: https://doi.org/10.15121/1879451

Citation Formats


                    Eijsink, Agathe, and Elsworth, Derek. Utah FORGE Friction-Permeability-Seismicity Laboratory Experiments with Non-Linear Acoustics.  United States: N. p., 2022. 
        Web.  doi:10.15121/1879451.

Copy to clipboard


                    Eijsink, Agathe, & Elsworth, Derek. Utah FORGE Friction-Permeability-Seismicity Laboratory Experiments with Non-Linear Acoustics.  United States.  doi:https://doi.org/10.15121/1879451

Copy to clipboard


                    Eijsink, Agathe, and Elsworth, Derek. 2022.  
"Utah FORGE Friction-Permeability-Seismicity Laboratory Experiments with Non-Linear Acoustics".  United States.  doi:https://doi.org/10.15121/1879451.  https://www.osti.gov/servlets/purl/1879451. Pub date:Fri Jul 08 04:00:00 UTC 2022

Copy to clipboard


                    
@article{osti_1879451,

  title        = {Utah FORGE Friction-Permeability-Seismicity Laboratory Experiments with Non-Linear Acoustics},

  author       = {Eijsink, Agathe and Elsworth, Derek},

  abstractNote = {Laboratory experimental data on saw-cut interface of Westerly Granite and Utah Forge granitoid rocks. Experiments include velocity-stepping and fluid pressure stepping experiments. Mechanical data from 3 ISCO pumps connected to a Temco pressure vessel measure axial, confining and fault: fluid pressure (kPa), fluid flow rate (mL/min) and volume remaining in pump (mL). Non-linear acoustic data acquired via Verasonics systems connected to PZTs inside the pressure vessel give the timeshift, amplitude and RMS amplitude of the passing P-wave.},

  doi          = {10.15121/1879451},

  journal      = {},

  number       = ,

  volume       = ,

  place        = {United States},

  year         = {Fri Jul 08 04:00:00 UTC 2022},

  month        = {Fri Jul 08 04:00:00 UTC 2022}

}

Copy to clipboard

Dataset:

View Dataset

DOI: https://doi.org/10.15121/1879451

Save / Share:

Export Metadata

Save to My Library

Similar records in DOE Data Explorer and OSTI.GOV collections:

Utah FORGE Hydrothermal Friction-Hydraulic Transmissivity Laboratory Experiments

Dataset Jeppson, Tamara ; Lockner, David

Submission includes data from laboratory slide-hold-slide tests, combined with flow through tests, conducted on Westerly granite with 30 degree sawcut. Tests were conducted with a constant confining pressure of 30 MPa with an average pore pressure of 10 MPa at temperatures of 23 and 200 degC. Three fluid flow conditions were examined (1) no flow, (2) cycled flow, and (3) continuous flow. Data were collected to asses the effect of temperature and pore fluid on frictional healing rates in granite at geothermal conditions. Data is available in XML and JSON data types.
Utah FORGE Core Material Friction Experiments

Dataset Marone, Chris ; Affinito, Raphael ; Eijsink, Aagje

The following folders contain 3 friction experiments on Utah FORGE core material from depths of 6735 - 8533ft. The experiment conditions range from 100% relative humidity at room temperature to fluid-saturated at 110C. Experiments were done on both intact samples in a single-direct shear configuration, double-direct shear, and gouge.
Utah FORGE: Fault Reactivation Through Fluid Injection Induced Seismicity Laboratory Experiments

Dataset Yu, Jiayi ; Eijsink, Agathe ; Elsworth, Derek

Included are results from shear reactivation experiments on laboratory faults pre-loaded close to failure and reactivated by the injection of fluid into the fault. The sample comprises a single-inclined-fracture (SIF) transecting a cylindrical sample of Westerly granite. All experiments are conducted at ambient temperature and follow a similar protocol: (i) application of confining stresses (3MPa) on the fault fully saturated with DI water, (ii) shear-mobilization through the increase of axial loading at a constant displacement rate until a post-peak steady-state condition is reached, (iii) reduction of axial loading and related shear stress to a prescribed fraction of the peak steady-statemore »« less
Utah FORGE 5-2419: Seismicity-Permeability Relationships Probed via Nonlinear Acoustic Imaging - Workshop Presentation

Dataset Elsworth, Derek ; Shokouhi, Parisa ; Riviere, Jacques ; ...

This is a presentation on the Seismicity-Permeability Relationships Probed via Nonlinear Acoustic Imaging project by Pennsylvania State University, presented by Derek Elsworth. The project's objectives were to explore controls and acoustic signatures of aseismic through seismic evolution of friction-stability-permeability relationships on fractures in shear-reactivation, link this reactivation to key features of the pre-existing stress state, and upscale these indexes to reservoir scale to drive successful reservoir stimulation. This presentation was featured in the Utah FORGE R&D Annual Workshop on September 8, 2023. The workshop provided a valuable opportunity to explore the progress made in each of the 17 Research andmore »« less
Utah FORGE: Seismic Reflection Data

Dataset Miller, John

This is 2D and 3D seismic reflection data from Utah FORGE reprocessed during Phase 2c. The readme file containing an explanation of the data including data formats, software that can be used, processing, and projection and datum used. The Reprocessing document gives the rationale for reprocessing and shows examples of the improvements that were obtained. For all 3D and 2D data the following datasets were created and output in SEG-Y format: - Unmigrated Time - Prestack Time Migration (PSTM), Unenhanced (UnEnh) and Enhanced (Enh) - Prestack Depth Migration (PSDM), Unenhanced (UnEnh) and Enhanced (Enh) - Velocity Model used for Migration

Similar Records