Magnetomechanics of internal-dipole, Halbach-array motor/generators.

Journal Article · Sat Jul 01 04:00:00 EDT 2000 · IEEE Trans. Magn.

DOI:https://doi.org/10.1109/20.875294· OSTI ID:942568

Hull, J R; Turner, L R

The magnetomechanical behavior of internal-dipole, Halbach-type magnet arrays is analyzed for application as a motor/generator (M/G) with an energy-storage flywheel that is suspended by low-stiffness bearings. Scaling laws for the maximization of torque are derived as a function of geometry. The optimal geometry is relatively insensitive to gap and stator design and occurs approximately at a ratio of inner to outer diameter of the array of 0.8. Values are found for the angular extent of each phase of the stator coil that minimize the stiffness. The negative stiffness of the internal-dipole array is calculated for several manufacturable configurations and is shown to provide an upper limit on the available torque of the M/G according to the positive stiffness of the bearings. Experimental results are reported for an internal-dipole array used as a M/G for a flywheel suspended by a bearing consisting of a permanent-magnet assembly levitated over an array of high-temperature superconductors. Results show that the system is stable and that idling losses are low.

• Research Organization: Argonne National Laboratory (ANL)
• Sponsoring Organization: EE
• DOE Contract Number: AC02-06CH11357
• OSTI ID: 942568
• Report Number(s): ANL/ET/JA-32647
• Journal Information: IEEE Trans. Magn., Journal Name: IEEE Trans. Magn. Journal Issue: 4 ; Jul. 2000 Vol. 36; ISSN IEMGAQ; ISSN 0018-9464
• Country of Publication: United States
• Language: ENGLISH

Related Subjects

25 ENERGY STORAGE
BEARINGS
ENERGY STORAGE
FLYWHEELS
MAGNETS
SCALING LAWS
STATORS
SUPERCONDUCTORS
TEMPERATURE RANGE 0400-1000 K
TORQUE