On-chip monitoring of MEMS gear motion.
We have designed and fabricated a polysilicon sidewall-contact motion monitor that fits in between the teeth of a MEMS gear. The monitor has a center grounded member that is moved into contact with a pad held at voltage. When observing motion, however, the monitor fails after only a few actuations. A thorough investigation of the contacting interfaces revealed that for voltages > 5 V with a current limit of 100 pA, the main conduction process is Fowler-Nordheim tunneling. After a few switch cycles, the polysilicon interfaces became insulating. This is shown to be a permanent change and the suspected mechanism is field-induced oxidation of the asperity contacts. To reduce the effects of field-induced oxidation, tests were performed at 0.5 V and no permanent insulation was observed. However, the position of the two contacting surfaces produced three types of conduction processes: Fowler-Nordheim tunneling, ohmic, and insulator, which were observed in a random order during switch cycling. The alignment of contact asperities produced this positional effect.
- Research Organization:
- Sandia National Laboratories (SNL), Albuquerque, NM, and Livermore, CA (United States)
- Sponsoring Organization:
- USDOE
- DOE Contract Number:
- AC04-94AL85000
- OSTI ID:
- 915179
- Report Number(s):
- SAND2003-0528C; TRN: US200817%%131
- Resource Relation:
- Conference: Proposed for presentation at the IEEE's International Reliability Physics Symposium held March 31-April 3, 2003 in Dallas, TX.
- Country of Publication:
- United States
- Language:
- English
Similar Records
Fatigue failure in thin-film polysilicon is due to subcriticalcracking within the oxide layer
Modifications of Fowler-Nordheim injection characteristics in {gamma} irradiated MOS devices