Anisotropy of mechanical properties of tuff at Yucca Mountain
The purpose of this study is to investigate anisotropy of mechanical properties, namely, compressive strength and modulus, for Tiva Canyon welded tuff from the starter tunnel at Yucca Mountain. Mechanical properties of Tiva Canyon Tuff are needed for the design of the ramps and drifts within the Tiva Canyon horizon. Approximately one cubic foot block samples, all of which were from the thermo -- mechanical unit TCw, were obtained from a muck pile containing excavated rock from the starter tunnel. Specimens were cored from the block samples in two distinct orientations: parallel and perpendicular to the lithophysal cavity orientation. Since lithophysal cavity orientation is predominantly horizontal in the field, parallel specimens can be considered horizontal and perpendicular specimens vertical with respect to the rock mass. The specimens were NX sized (5.4 cm diameter) and had a length-to-diameter ratio of 2:1. The air dried specimens were tested at room temperature in a triaxial chamber at confining pressures of 0.1, 5, and 10 MPa, and at a compressive axial strain rate of 10{sup {minus}5} s{sup {minus}}. The Young`s Modulus values were calculated by a least squares fit of stress - strain data between 10 and 50% of the ultimate strength.
- Research Organization:
- Nevada Univ., Las Vegas, NV (United States)
- Sponsoring Organization:
- USDOE, Washington, DC (United States)
- DOE Contract Number:
- FC08-90NV10872
- OSTI ID:
- 90377
- Report Number(s):
- CONF-950570--24; ON: DE95013014
- Country of Publication:
- United States
- Language:
- English
Similar Records
The effect of saturation of the mechanical properties of tuff at Yucca Mountain
Thermal expansion, thermal conductivity, and heat capacity measurements for boreholes UE25 NRG-4, UE25 NRG-5, USW NRG-6, and USW NRG-7/7A