Development of a single-layer Nb3Sn common coil dipole model
Conference
·
OSTI ID:805822
- Fermilab
A high-field dipole magnet based on the common coil design was developed at Fermilab for a future Very Large Hadron Collider. A short model of this magnet with a design field of 11 T in two 40-mm apertures is being fabricated using the react-and-wind technique. In order to study and optimize the magnet design two 165-mm long mechanical models were assembled and tested. A technological model consisting of magnet straight section and ends was also fabricated in order to check the tooling and the winding and assembly procedures. This paper describes the design and technology of the common coil dipole magnet and summarizes the status of short model fabrication.The results of the mechanical model tests and comparison with FE mechanical analysis are also presented.
- Research Organization:
- Fermi National Accelerator Lab., Batavia, IL (US)
- Sponsoring Organization:
- USDOE Office of Energy Research (ER) (US)
- DOE Contract Number:
- AC02-76CH03000
- OSTI ID:
- 805822
- Report Number(s):
- FERMILAB-Conf-02/182
- Country of Publication:
- United States
- Language:
- English
Similar Records
Design and development of Nb{sub 3}Sn single-layer common coil dipole magnet for VLHC
R $\&$ D for a Single-Layer Nb$_3$Sn Common Coil Dipole Using the React-and-Wind Fabrication Technique
Development and test of a large-aperture Nb3Sn cos-theta dipole coil with stress management
Conference
·
Mon Jul 30 00:00:00 EDT 2001
·
OSTI ID:783677
R $\&$ D for a Single-Layer Nb$_3$Sn Common Coil Dipole Using the React-and-Wind Fabrication Technique
Conference
·
Wed Aug 07 00:00:00 EDT 2002
· IEEE Trans.Appl.Supercond.
·
OSTI ID:790168
Development and test of a large-aperture Nb3Sn cos-theta dipole coil with stress management
Conference
·
Mon Jul 01 00:00:00 EDT 2024
· JACoW
·
OSTI ID:2439272