Ripple feedback for the resonant-filter unity-power-factor rectifier

Journal Article · Wed Jul 01 04:00:00 EDT 1992 · IEEE Transactions on Power Electronics (Institute of Electrical and Electronics Engineers); (United States)

DOI:https://doi.org/10.1109/63.145132· OSTI ID:7278811

Streng, S A ^[1]; King, R J ^[2]

---

1. GE Transportation Systems, General Electric Co., Erie, PA (US)
2. Dept. of Electrical Engineering, Univ. of Toledo, Toledo, OH (US)

An unusual bucklike unity-power-factor rectifier with a resonant load-balancing network permits current-limited operation down to zero output voltage in a single-stage-topology. However, this rectifier has been found to be sensitive to ac-line voltage distortion and is potentially unstable with realistic values of ac-line impedance. In this paper, a new ripple feedback is proposed that solves both problems. A large-signal time-varying analysis is given along with incremental, quasi-static, and low-frequency approximations. Experimental verification is provided by a 500-W 50-kHz rectifier operating from the 120-V 60-Hz distribution system.

• OSTI ID: 7278811
• Journal Information: IEEE Transactions on Power Electronics (Institute of Electrical and Electronics Engineers); (United States), Journal Name: IEEE Transactions on Power Electronics (Institute of Electrical and Electronics Engineers); (United States) Vol. 7:3; ISSN 0885-8993; ISSN ITPEE
• Country of Publication: United States
• Language: English

Related Subjects

24 POWER TRANSMISSION AND DISTRIBUTION
240200 -- Power System Networks
Transmission & Distribution-- (1990-)
42 ENGINEERING
426000* -- Engineering-- Components
Electron Devices & Circuits-- (1990-)
AC SYSTEMS
ELECTRIC IMPEDANCE
ELECTRICAL EQUIPMENT
EQUIPMENT
FEEDBACK
FLUCTUATIONS
FREQUENCY RANGE
IMPEDANCE
KHZ RANGE
KHZ RANGE 01-100
OPERATION
POWER DISTRIBUTION SYSTEMS
POWER FACTOR
POWER SYSTEMS
RECTIFIERS
RESONANCE
SENSITIVITY
VARIATIONS