Degradation of the shape memory effect in copper-base alloys
- Katholieke Univ. Leuven, Heverlee (Belgium). Dept. of Metallurgy and Materials Science
The reversible transformation of the parent phase (austenite) to the product phase (martensite) is the basis of several shape memory properties in specific Cu-base alloys. In this respect, the two-way memory effect (TWME) refers the reversible, spontaneous shape change from a hot austenitic shape to a cold martensitic shape during cooling and heating without the application of external stresses. It is known that the magnitude of the TWME decrease during thermal or thermomechanical cycling, in particular in Cu-base shape memory alloys. It is however important to remark that this decrease, indicated as degradation of the TWME, can be caused as well by a decrease of the spontaneous martensitic strain, i.e. a degradation of the cold shape, as by an increase of the residual austenitic strain, i.e. a degradation of the hot shape, or by a combination of both. The degradation of the TWME, and of the hot and cold shape is influenced by a number of factors including the alloy composition, the processing, the heat treatment, the training procedure and the parameters of the thermal or thermomechanical cycling. The knowledge of the degradation phenomena is still limited. In a subsequent study of the relationships between training and the two-way memory behavior, the authors have shown that the degradation of the hot shape already starts during training. It was found that the residual austenitic strain [gamma][sub a] increases gradually during training cycling; [gamma][sub a] is also in the case of training composed of a recoverable residual strain [gamma][sub ar] and a non-recoverable residual strain [gamma][sub anr]. The present paper reports the results of the specific experiments which were designed based upon the results described above. The evolutions during thermal cycling of the TWME, of the martensitic strain and austenitic strain, and of the recoverable and non-recoverable austenitic strain are presented and discussed.
- OSTI ID:
- 6935631
- Journal Information:
- Scripta Metallurgica et Materialia; (United States), Vol. 31:11; ISSN 0956-716X
- Country of Publication:
- United States
- Language:
- English
Similar Records
The training and re-training procedures for the two way memory effect and its degradation in a Cu-Al-Be alloy
The two-way memory effect by the pre-strain training method in a 50Ti40Ni10Cu (at.%) alloy