Skip to main content
U.S. Department of Energy
Office of Scientific and Technical Information

YBCO microwave grain boundary mixer using a SrTiO[sub 3] bicrystal substrate

Conference · · IEEE Transactions on Magnetics (Institute of Electrical and Electronics Engineers); (United States)
OSTI ID:6784025
; ; ; ;  [1]
  1. Northeastern Univ., Boston, MA (United States)

A microwave mixer was patterned on a microstrip transmission line of superconducting YBCO (YBa[sub 2]Cu[sub 3]O[sub 7[minus]x]). The YBCO film was epitaxially laser deposited on a SrTiO[sub 3] bicrystal substrate. A weak link was constructed by patterning a microbridge In the microstrip at the bicrystal boundary. Two microwave signals were applied at the input of the microstrip line, one signal at 9.000 GM and the other signal at 9.941 GHz. An output intermediate frequency signal was observed at 941 MHz and was detected as the transmitted signal. The microbridge junction, which behaved as a resistively shunted Josephson junction (RSJ), was current biased slightly above the critical current I[sub c]. The mixer conversion loss was measured at the input and output ports of the device package. With these measurements, the mixing efficiency was determined at the device junction, and this measured efficiency was compared with the calculated efficiency. The calculated efficiency was determined by numerical solution of the Josephson equation for the weak link junction.

OSTI ID:
6784025
Report Number(s):
CONF-930416--
Journal Information:
IEEE Transactions on Magnetics (Institute of Electrical and Electronics Engineers); (United States), Journal Name: IEEE Transactions on Magnetics (Institute of Electrical and Electronics Engineers); (United States) Vol. 29:6; ISSN IEMGAQ; ISSN 0018-9464
Country of Publication:
United States
Language:
English