Monte Carlo boundary source approach in MOX fuel test capsule design
- Idaho National Engineering and Environmental Lab., Idaho Falls, ID (United States)
To demonstrate that the differences between weapons-grade (WG) mixed oxide (MOX) and reactor-grade MOX fuel are minimal, and therefore the commercial MOX experience base is applicable, an average power test (6 to 10 kW/ft) of WG MOX fuel was inserted into the Advanced Test Reactor (ATR) in January 1998. A high-power test (10 to 15 kW/ft) of WG MOX fuel in ATR is being fabricated as a follow-on to the average-power test. Two MOX capsules with 8.9 GWd/t burnup were removed from ATR on September 13, 1998, and replaced by two fresh WG MOX fuel capsules in regions with less thermal neutron flux (top-1 and bottom-1, which are away from the core center). To compensate for {sup 239}Pu depletion, which causes the linear heat generation rates (LHGRs) to decrease, the INCONEL shield was replaced by an aluminum shield in the phase-II irradiation. The authors describe and compare the results of the detailed MCNP ATR quarter core model (QCM) and isolated box model with boundary source (IBMBS). Physics analysis were performed with these two different models to provide the neutron/fission heat rate distribution data in the WG MOX fuel test assembly, with INCONEL and aluminum shrouds, located in the small I-24 hole of ATR.
- OSTI ID:
- 678163
- Report Number(s):
- CONF-990605-; ISSN 0003-018X; TRN: 99:009148
- Journal Information:
- Transactions of the American Nuclear Society, Vol. 80; Conference: 1999 annual meeting of the American Nuclear Society (ANS), Boston, MA (United States), 6-10 Jun 1999; Other Information: PBD: 1999
- Country of Publication:
- United States
- Language:
- English
Similar Records
Weapons-Grade MOX Fuel Burnup Characteristics in Advanced Test Reactor Irradiation
Monte-Carlo Code (MCNP) Modeling of the Advanced Test Reactor Applicable to the Mixed Oxide (MOX) Test Irradiation