Skip to main content
U.S. Department of Energy
Office of Scientific and Technical Information

Langmuir-Blodgett manipulation of electrically conductive polypyrroles

Journal Article · · Journal of Physical Chemistry; (USA)
DOI:https://doi.org/10.1021/cm00007a012· OSTI ID:6716560
; ;  [1]
  1. Massachusetts Institute of Technology, Cambridge (USA)
Electrically conductive polypyrroles have been synthesized at the air-water interface of a Langmuir-Blodgett film balance by spreading mixtures of pyrrole monomer and a surface-active pyrrole derivative (3-octadecylpyrrole or 3-octadecanoylpyrrole) onto a subphase containing ferric chloride. The thickness and conductivity of the resultant polymers were found to depend strongly on the mole ratio of surface-active pyrrole to pyrrole monomer used in the dispersing solvent. It is possible to create films at the air-water interface ranging in thickness from monolayer to multilayer by varying this mole ratio and the type of surface-active pyrrole added to the spreading solution. The most highly conducting films (about 10{sup {minus}1} S/cm) were produced with mole ratios of pyrrole to surface-active pyrrole approaching 5000/1. Multilayers of these films were fabricated successfully by both the horizontal and vertical lifting methods. The conductivity of multilayers formed from the 3-octadecanoylpyrrole/pyrrole system was found to be highly anisotropic, with conductivities in the plane of the film about 10{sup 7} times greater than conductivities across the film thickness. Superlattice films comprised of electrically conductive polypyrrole rich bilayers alternating with insulating bilayers of surface-active pyrrole molecules were also fabricated.
OSTI ID:
6716560
Journal Information:
Journal of Physical Chemistry; (USA), Journal Name: Journal of Physical Chemistry; (USA) Vol. 2:1; ISSN 0022-3654; ISSN JPCHA
Country of Publication:
United States
Language:
English