Skip to main content
U.S. Department of Energy
Office of Scientific and Technical Information

Seismicity of the central United States

Journal Article · · Rev. Eng. Geol.; (United States)
DOI:https://doi.org/10.1130/REG4-p65· OSTI ID:6248290

The combination of moderate seismic activity, sparsity of seismograph stations and relatively low density of population makes it difficult to assign quantitative seismicity values to most of the central United States. The seismicity data suggest that earthquakes that occur outside the recognized seismic zones or major structural features will have a maximum body-wave magnitude m/sub b/ of 5.5 and that this maximum value will occur only infrequently. Experience shows that if these relatively minor earthquakes are only a few kilometres deep they may have an epicentral intensity at least as large as VII (observed for an earthquake of m/sub b/ = 3.8), but their magnitude and area of perceptibility will be small. With the exception of the New Madrid seismic zone and possibly the Wabash Valley seismic zone, a conservatively reasonable value for the maximum body-wave magnitude to be expected in the major seismic and structural zones of the central United States is 6.5. For the New Madrid seismic zone an earthquake of body-wave magnitude equivalent to that of a great earthquake (m/sub b/ = 7.5) can be expected, on the basis of what has already been experienced in 1811-1812. Because of low anelastic attenuation, the earthquakes in the central United States are felt and cause damage over much wider areas than earthquakes of comparable magnitude in the western United States. Further consequences are that the ground shaking has a longer duration and that the ground-motion spectrum shifts at the larger distances to lower frequencies, which results in relatively low ground acceleration for relatively large ground displacements and a greater effect on high-rise than low-rise structures. (JMT)

Research Organization:
St. Louis Univ., MO
OSTI ID:
6248290
Journal Information:
Rev. Eng. Geol.; (United States), Journal Name: Rev. Eng. Geol.; (United States) Vol. 4; ISSN RENGD
Country of Publication:
United States
Language:
English