Skip to main content
U.S. Department of Energy
Office of Scientific and Technical Information

Computational modeling of wall-supported dense Z-pinches

Journal Article · · AIP Conference Proceedings
DOI:https://doi.org/10.1063/1.53834· OSTI ID:606133
In our previous computational modeling of deuterium-fiber-initiated Z-pinches intended for ohmic self-heating to fusion conditions, instability-driven expansion caused densities to drop far below those desired for fusion applications; such behavior has been observed on experiments such as Los Alamos{close_quote} HDZP-II. A new application for deuterium-fiber-initiated Z-pinches is Magnetized Target Fusion (MTF), in which a preheated and magnetized target plasma is hydrodynamically compressed, by a separately driven liner, to fusion conditions. Although the conditions necessary for a suitable target plasma{emdash}density O(10{sup 18}cm{sup {minus}3}), temperature O(100 eV), magnetic field O(100 kG){emdash}are less extreme than those required for the previous ohmically heated fusion scheme, the plasma must remain magnetically insulated and clean long enough to be compressed by the imploding liner to fusion conditions, e.g., several microseconds. A fiber-initiated Z-pinch in a 2-cm-radius, 2-cm long conducting liner has been built at Los Alamos to investigate its suitability as an MTF target plasma. Two-dimensional magnetohydrodynamic modeling of this experiment shows early instability similar to that seen on HDZP-II; however, when plasma finds support and stabilization at the outer radial wall, a relatively stable profile forms and persists. Comparison of experimental results and computations, and computational inclusion of additional experimental details is being done. Analytic and computational investigation is also being done on possible instability-driven cooling of the plasma by Benard-like convective cells adjacent to the cold wall. {copyright} {ital 1997 American Institute of Physics.}
Research Organization:
Los Alamos National Laboratory (LANL), Los Alamos, NM (United States)
Sponsoring Organization:
USDOE
OSTI ID:
606133
Report Number(s):
CONF-9705120--
Journal Information:
AIP Conference Proceedings, Journal Name: AIP Conference Proceedings Journal Issue: 1 Vol. 409; ISSN 0094-243X; ISSN APCPCS
Country of Publication:
United States
Language:
English

Similar Records

Computational modeling of wall-supported dense Z-pinch
Conference · Fri Oct 31 23:00:00 EST 1997 · OSTI ID:542048

Computational modeling of wall-supported dense Z-pinches
Conference · Tue Dec 30 23:00:00 EST 1997 · OSTI ID:323584

Computational modeling of wall-supported dense Z-pinches
Journal Article · Mon May 05 00:00:00 EDT 1997 · AIP Conference Proceedings · OSTI ID:21172304