skip to main content
OSTI.GOV title logo U.S. Department of Energy
Office of Scientific and Technical Information

Title: Transient dehumidification characteristics of a heat pump in cooling mode

Journal Article · · Journal of Solar Energy Engineering; (United States)
DOI:https://doi.org/10.1115/1.2929972· OSTI ID:5861994
;  [1]
  1. Energy Systems Lab., Dept. of Mechanical Engineering, Texas A and M Univ., College Station, TX (US)

This paper reports that much of the seasonal cooling operation of the heat pump occurs at part-load conditions when the unit cycles on and off to meet the cooling load. The seasonal efficiency under part-load conditions of the heat pump is typically estimated from a laboratory measurement of the degradation coefficient (C{sub D}). Manufacturers are only required to estimate C{sub D} at a single test condition where the indoor coil performs sensible cooling only. The effects of transient dehumidification losses are not accounted in estimating the seasonal efficiency. In hot and humid climates, dehumidification performance of a heat pump is as important as the sensible cooling performance. Therefore, a series of tests were designed to quantify the part-load dehumidification characteristics of a three ton residential air-to-air heat pump. The tests include: cycling rates from 0.8 to 10 cycles per hour (cph), percent on-times of 20, 50, and 80 percent, indoor dry-bulb temperature between 22.2{degrees}C and 26.7{degrees}C, and indoor air flow rate were constant for all test runs. All experiments were performed in psychrometric chambers under controlled conditions. The dehumidification process started between 60 to 150 seconds after start-up depending on the test conditions. During start-up, the losses in the latent capacity were greater than the losses in the sensible capacity. The dehumidification response increased with indoor dry-bulb temperature at constant relative humidity and decreased with indoor temperature at constant dew-point temperature.

OSTI ID:
5861994
Journal Information:
Journal of Solar Energy Engineering; (United States), Vol. 113:4; ISSN 0199-6231
Country of Publication:
United States
Language:
English