In situ stress measurements in inclined holes in the North Sea: application to enhanced oil recovery
Eighteen in situ stress measurements were made in two 3.5 km deep wells in a reservoir located in the Viking Graben region of the North Sea. The wellbores were inclined 60/sup 0/ and 70/sup 0/ from the vertical. The principal in situ stress directions and magnitudes were determined by the anelastic strain recovery method. The principal stress directions were determined directly from measurements of the principal strain recovery directions of oriented core immediately after it was retrieved from the wellbore. The principal stress magnitudes were calculated from the principal strain recovery magnitudes, overburden stress, and elastic properties of the rock using a creep recovery model. The reliability and accuracy of the strain recovery method has been documented in several vertical holes by direct comparison with open hole hydraulic fracture stress measurements. In the two inclined holes in the North Sea, the maximum principal stress was the overburden, and the average ratios of the maximum and minimum horizontal stresses to the overburden were 0.93 and 0.78, respectively. The azimuth of the maximum horizontal stress (and hydraulic fracture) was N72/sup 0/W +- 21/sup 0/. The measured stress orientations are consistent with a geologic and tectonic model of the region. The calculated stress magnitudes indicate that potential hydraulic fractures created during the EOR program will be vertical and have a well defined azimuth because the overburden is the maximum stress and there is sufficient difference between the two principal horizontal stresses. The high ratio of the minimum stress to overburden indicates that high injection pressures will be required during stimulation, and this should be included in the stimulation design to optimize fracture length. Fracture length will depend upon the permeability of the formation, water quality, the total injected volume, and injection pressures.
- Research Organization:
- Sandia National Labs., Albuquerque, NM (USA)
- DOE Contract Number:
- AC04-76DP00789
- OSTI ID:
- 5589386
- Report Number(s):
- SAND-85-0076C; CONF-850941-1; ON: DE85006740
- Country of Publication:
- United States
- Language:
- English
Similar Records
Determination of in situ stress from anelastic strain recovery measurements of oriented core: comparison to hydraulic fracture stress measurements in the Rollins Sandstone, Piceance Basin, Colorado
A field test of the strain recovery method of stress determination in Devonian shale
Related Subjects
020300* -- Petroleum-- Drilling & Production
ATLANTIC OCEAN
DIRECTIONAL DRILLING
DRILLING
ENERGY SOURCES
ENHANCED RECOVERY
FAILURES
FLUID INJECTION
FOSSIL FUELS
FRACTURES
FUELS
HYDRAULIC FRACTURES
MEASURING METHODS
NORTH SEA
OFFSHORE OPERATIONS
OPTIMIZATION
ORIENTATION
PETROLEUM
RECOMMENDATIONS
RECOVERY
RESERVOIR ROCK
SEAS
STIMULATION
STRAINS
STRESSES
SURFACE WATERS
WATERFLOODING
WELL STIMULATION
WELLS