Effects of laminar flow control on the performance of a large span-distributed-load flying-wing cargo airplane concept
The effects of laminar flow control (LFC) on the performance of a large span-distributed-load flying-wing cargo airplane concept having a design payload of 2.669 MN and range of 5.93 Mm were determined. Two configurations were considered. One employed laminarized flow over the entire surfaces of the wing and vertical tails, with the exception of the estimated areas of interference due to the fuselage and engines. The other case differed only in that laminar flow was not applied to the flaps, elevons, spoilers, or rudders. The two cases are referred to as the 100 percent and 80 percent laminar configurations, respectively. The utilization of laminar flow control results in reductions in the standard day, sea level installed maximum static thrust per engine from 240 kN for the non-LFC configuration to 205 kN for the 100 percent laminar configuration and 209 kN for the 80 percent case. Weight increases due to the LFC systems cause increases in the operating empty weights of approximately 3 to 4 percent. The design takeoff gross weights decrease approximately 3 to 5 percent. The FAR-25 takeoff field distances for the LFC configurations are greater by about 6 to 7 percent. Fuel efficiencies for the respective configurations are increased 33 percent and 23 percent.
- Research Organization:
- National Aeronautics and Space Administration, Langley AFB, VA (USA). Langley Research Center
- OSTI ID:
- 5589277
- Report Number(s):
- N-79-17851
- Country of Publication:
- United States
- Language:
- English
Similar Records
Wing planform geometry effects on large subsonic military transport airplanes. Final technical report March 1976-February 1977
Automated airplane surface generation