Beam profile monitors for very small transverse and longitudinal dimensions using laser interferometer and heterodyne techniques
- KEK: National Laboratory for High Energy Physics Tsukuba, Ibaraki 305 (Japan)
In future e{sup +}e{sup {minus}} linear colliders of 0.5-1 TeV center-of-mass energy region, very small beam sizes will be used at the interaction region in order to get enough beam-beam luminosity. Typical design parameters assume a cross section of 3{endash}5 nm by 300 nm in vertical and horizontal, respectively, and a bunch length of 0.1 mm. In order to measure the nanometer vertical size, we use laser interference fringes. By scanning the electron beam over the fringe pattern and monitoring the high-energy gamma rays due to Compton scattering, beam information can be obtained. The modulation depth in the gamma-ray flux gives the spot size information. This method was used in the Final Focus Test Beam (FFTB) test at SLAC, and a 70-nm spot was measured. To measure the longitudinal bunch length, a new method, utilizing a laser-heterodyne technique, will be proposed in this paper. {copyright} {ital 1997 American Institute of Physics.}
- OSTI ID:
- 526796
- Report Number(s):
- CONF-9605173--
- Journal Information:
- AIP Conference Proceedings, Journal Name: AIP Conference Proceedings Journal Issue: 1 Vol. 390; ISSN 0094-243X; ISSN APCPCS
- Country of Publication:
- United States
- Language:
- English
Similar Records
Experiments of Nanometer Spot Size Monitor at FETB Using Laser Interferometry
A laser-heterodyne bunch length monitor for the SLC interaction point
First Beam Test of Nanometer Spot Size Monitor Using Laser Interferometry
Technical Report
·
Thu Jun 12 20:00:00 EDT 2003
·
OSTI ID:813237
A laser-heterodyne bunch length monitor for the SLC interaction point
Conference
·
Thu May 01 00:00:00 EDT 1997
·
OSTI ID:513520
First Beam Test of Nanometer Spot Size Monitor Using Laser Interferometry
Technical Report
·
Tue Jun 24 20:00:00 EDT 2003
·
OSTI ID:813279