Skip to main content
U.S. Department of Energy
Office of Scientific and Technical Information

Potentiometric oxygen sensor operable in low temperature by applying LaGaO{sub 3}-based oxide for electrolyte

Journal Article · · Journal of the Electrochemical Society
DOI:https://doi.org/10.1149/1.1837632· OSTI ID:511932
Oxygen sensors are important for combustion control, in particular, for vehicles. A perovskite-type oxide of LaGaO{sub 3} doped with Sr and Mg exhibits a high oxide ion conductivity over a wide range of oxygen partial pressures. In this study, the application of LaGaO{sub 3}-based oxide as the electrolyte of a potentiometric oxygen sensor was investigated. It became clear that silver is the most effective electrode for decreasing the operating temperature. Although a temperature higher than 800 K is required when a conventional Y{sub 2}O{sub 3}-stabilized ZrO{sub 2} electrolyte is used, an operating temperature as low as 600 K is adequate when La{sub 1{minus}x}Sr{sub x}Ga{sub 0.8}Mg{sub 0.2}O{sub 3} at X = 0.1 and 0.2 is used. The open-circuit potential was slightly smaller than that estimated with the Nernst equation. There was agreement with the Nernst equation down to 673 K when Nd-doped LaGaO{sub 3}-based oxide was used. Moreover, 90% of the response was attained within 15 s at 673 K for the sensor with Nd-doped LaGaO{sub 3}-based oxide.
Sponsoring Organization:
USDOE
OSTI ID:
511932
Journal Information:
Journal of the Electrochemical Society, Journal Name: Journal of the Electrochemical Society Journal Issue: 5 Vol. 144; ISSN JESOAN; ISSN 0013-4651
Country of Publication:
United States
Language:
English