BURNOUT CONDITIONS FOR FLOW OF BOILING WATER IN VERTICAL ROD CLUSTERS

Journal Article · Fri Mar 01 04:00:00 EST 1963 · A.I.Ch.E. (Am. Inst. Chem. Engrs.) J.

DOI:https://doi.org/10.1002/aic.690090216· OSTI ID:4755058

Becker, K M

A new concept is described for predicting burnout conditions for forced convection of boiling water in fuel elements of nuclear boiling reactors. The concept states the importance of considering the ratio of heated channel perimeter to total channel perimeter. The perimeter ratio concept was arrived at from an experimental study of burnout conditions in rod clusters consisting of three rods of 13 mm outside diameter and 830 mm heated length. Data were obtained for pressures between 2.5 and 10 kg/cm/sup 2/, surface heat fluxes between 50 and 120 w/cm/sup 2/, mass flow rates between 0.03 and 0.33 kg/sec, and steam qualities between 0.01 and 0.52. The rod clearances for the experiment were 2 and 6 mm. The diameter of the channel was 41.3 mm. Additional runs were also performed after unheated displacement rods were introduced in the channel. The rod clearance in this case was 6 mm. In the ranges investigated the measured burnout steam qualities at the outlet of the channel decrease with increasing heat flux and decreasing pressure. Furthermore, it was found that the influence of rod clearance is, in the range investigated, of small significance for engineering purposes. It was also observed that the present burnout steam quality data for the rod clusters are much lower than those earlier obtained for round ducts. This may be explained physically by means of the perimeter ratio concept. It was also found that the surface shear stress distribution around the channel perimeter and especially the position of maximum shear stress is of great importance for predicting burnout conditions for flow in channels. Finally the new method has helped in understanding and interpreting experimental results which earlier may have seemed inconsistent. (auth)

• Research Organization: Aktiebolaget Atomenerg, Studsvik, Sweden
• NSA Number: NSA-17-016238
• OSTI ID: 4755058
• Report Number(s): AE-74
• Journal Information: A.I.Ch.E. (Am. Inst. Chem. Engrs.) J., Journal Name: A.I.Ch.E. (Am. Inst. Chem. Engrs.) J. Vol. Vol: 9
• Country of Publication: Country unknown/Code not available
• Language: English

Related Subjects

BOILING
BURNOUT
CONFIGURATION
CONVECTION
COOLANT LOOPS
DISTRIBUTION
ENGINEERING AND EQUIPMENT
FLUID FLOW
FUEL ELEMENTS
HEATING
MASS
MEASURED VALUES
PERFORMANCE
PRESSURE
STEAM
STEAM QUALITY
STRESSES
SURFACES
TUBES
VELOCITY
WATER
WATER COOLANT