Skip to main content
U.S. Department of Energy
Office of Scientific and Technical Information

Destruction of hazardous wastes using Plasma Arc Technology

Conference ·
OSTI ID:469816
 [1];  [2]
  1. Army Environmental Center, Aberdeen Proving Ground, MD (United States)
  2. Concurrent Technologies Corp., Johnstown, PA (United States)
A Plasma Arc Technology (PAT) system treats hazardous wastes in a furnace, at temperatures of 2000{degrees}C, or higher, using a plasma torch. The organic components vaporize, decompose or oxidize. The off-gases consist of hydrogen, carbon monoxide, carbon dioxide and nitric oxides. A wet air scrubber is used to remove most of these gases. The scrubber water is treated and recycled. Metal-bearing solids are melted or vaporized. The solids are usually recovered as molten metal, or as non-leachable vitrified slag, suitable for disposal in a landfill. A Plasma Arc Centrifugal Treatment system was used to evaluate this technology for destruction of the four military hazardous wastes. The evaluation, Phase 1 of a two-phase program, includes determining the process capability of PAT for the ultimate destruction of hazardous components; verifying the suitability of the resulting slag for regular landfill disposal; identifying potential hazards associated with the process emissions; and developing qualified cost estimates for the future utilization of the process on large scale operations. Process variables such as feed rate, composition of off-gases, run duration, percentage of oxygen used in the secondary chamber, and chamber temperature are controlled. Material balance, destruction and removal efficiency (DRE), air emission quality, wastewater quality, and suitability of slag for landfill are determined. The results from these test runs and analyses are presented in this paper. The ultimate success of PAT for destroying hazardous wastes depends on achieving a slag that is non-leachable and meets Resource Conservation and Recovery Act (RCRA) requirements, and off-gases and scrubber water that meet Clean Air and Clean Water Act standards. Preliminary results of Phase I show that all slags passed Toxicity Characteristics Leaching Procedure (TCLP) tests, for land disposal requirements; air quality meets California standards, and scrubber water can be treated and recycled.
OSTI ID:
469816
Report Number(s):
CONF-960804--Vol.1
Country of Publication:
United States
Language:
English

Similar Records

Destruction of hazardous military wastes using plasma arc technology
Book · Mon Dec 30 23:00:00 EST 1996 · OSTI ID:442702

Introduction to Exide Corporations`s high temperature metals recovery system
Book · Sat Dec 30 23:00:00 EST 1995 · OSTI ID:175905

Thermal destruction of solid wastes
Journal Article · Sun Sep 01 00:00:00 EDT 1996 · Journal of Energy Resources Technology · OSTI ID:377884