Through bulkhead initiator studies
- Sandia National Labs., Albuquerque, NM (United States). Explosive Subsystems and Materials Dept.
This report describes recent work done to demonstrate feasibility of a fail-safe Through Bulkhead Initiator with minimum dimensions and suitable for use in cyclical thermal environments. Much of the ground work for a fail-safe TBI was previously done by A.C. Schwartz. This study is an expansion of Schwartz`s work to evaluate devices with bulkheads of 304 stainless steel and Inconel 718; explosive donors of PETN, BNCP, and a 0.005 inch thick steel flying plate donor traveling at 2.6 mm/{micro}s; and explosive acceptors of PETN and BNCP. Bulkhead thickness were evaluated in the range of 0.040 to 0.180 inch. The explosive acceptors initiated a small HMX pellet to drive a 0.005 inch thick steel flying plate, and VISAR histories of the HMX-driven flying plates were the measure of acceptable performance. A companion set of samples used a PMMA acceptor to measure the particle velocities at the bulkhead/PMMA interface with VISAR. These data were used to compute the input pressure to the acceptor explosives in an attempt to measure initiation threshold. Unfortunately, the range of bulkhead thicknesses tested did not give any failures, thus the threshold was not determined. It was found that either explosive or the flying plate would perform as a TBI in the bulkhead thickness range tested. The optimum TBI is about 0.060 inches thick, and steel bulkheads seem to be more structurally sound than those made of Inconel. That is, cross section views of the Inconel bulkheads showed it to be more prone to stress cracking than was the 304 stainless steel. Both PETN and BNCP showed good performance when tested at {minus}65 F following thermal cycling of {minus}65 F to +165 F. Analysis of the TBI function times showed that BNCP acceptor explosives were undergoing the classical deflagration to detonation process. The PETN acceptors were undergoing prompt detonation.
- Research Organization:
- Sandia National Lab. (SNL-NM), Albuquerque, NM (United States)
- Sponsoring Organization:
- USDOE, Washington, DC (United States)
- DOE Contract Number:
- AC04-94AL85000
- OSTI ID:
- 463627
- Report Number(s):
- SAND-97-0582; ON: DE97004746; TRN: AHC29709%%64
- Resource Relation:
- Other Information: PBD: Mar 1997
- Country of Publication:
- United States
- Language:
- English
Similar Records
Ignition and initiation of potassium picrate and potassium picrate/explosives mixtures
Ignition and deflagration of potassium picrate (KP) and KP/explosives mixtures: low-voltage, nonprimary detonators