Friction and abrasion resistance of cast aluminum alloy-fly ash composites
Journal Article
·
· Metallurgical and Materials Transactions. A, Physical Metallurgy and Materials Science
- Univ. of Wisconsin, Milwaukee, WI (United States). Dept. of Materials
- Univ. of Roorkee (India). Dept. of Metallurgical Engineering
The abrasive wear properties of stir-cast A356 aluminum alloy-5 vol pct fly ash composite were tested against hard SiC{sub p} abrasive paper and compared to those of the A356 base alloy. The results indicate that the abrasive wear resistance of aluminum-fly ash composite is similar to that of aluminum-alumina fiber composite and is superior to that of the matrix alloy for low loads up to 8 N (transition load) on a pin. At loads greater than 8 N, the wear resistance of aluminum-fly ash composite is reduced by debonding and fracture of fly ash particles. Microscopic examination of the worn surfaces, wear debris, and subsurface shows that the base alloy wears primarily by microcutting, but the composite wears by microcutting and delamination caused by crack propagation below the rubbing surface through interfaces between fly ash and silicon particles and the matrix. The decreasing specific wear rates and friction during abrasion wear with increasing load have been attributed to the accumulation of wear debris in the spaces between the abrading particles, resulting in reduced effective depth of penetration and eventually changing the mechanism from two-body to three-body wear, which is further indicated by the magnitude of wear coefficient.
- OSTI ID:
- 438600
- Journal Information:
- Metallurgical and Materials Transactions. A, Physical Metallurgy and Materials Science, Journal Name: Metallurgical and Materials Transactions. A, Physical Metallurgy and Materials Science Journal Issue: 1 Vol. 28; ISSN 1073-5623; ISSN MMTAEB
- Country of Publication:
- United States
- Language:
- English
Similar Records
Microstructure and wear characterization of aluminum matrix composites reinforced with industrial waste fly ash particulates synthesized by friction stir processing
Wear mechanisms in hybrid composites of graphite-20 pct SiC in A356 aluminum alloy (Al-7 pct Si-0. 3 pct Mg)
Effect of microstructure (particulate size and volume fraction) and counterface material on the sliding wear resistance of particulate-reinforced aluminum matrix composites
Journal Article
·
Mon Aug 15 00:00:00 EDT 2016
· Materials Characterization
·
OSTI ID:22689577
Wear mechanisms in hybrid composites of graphite-20 pct SiC in A356 aluminum alloy (Al-7 pct Si-0. 3 pct Mg)
Journal Article
·
Sat Dec 31 23:00:00 EST 1994
· Metallurgical Transactions, A (Physical Metallurgy and Materials Science); (United States)
·
OSTI ID:6607413
Effect of microstructure (particulate size and volume fraction) and counterface material on the sliding wear resistance of particulate-reinforced aluminum matrix composites
Journal Article
·
Sun May 01 00:00:00 EDT 1994
· Metallurgical Transactions, A (Physical Metallurgy and Materials Science); (United States)
·
OSTI ID:7276526