Skip to main content
U.S. Department of Energy
Office of Scientific and Technical Information

Characterization of the LGFSTF wind tunnel in preparation for the DOE/EPA hazardous chemical evaporation rate experiments

Technical Report ·
DOI:https://doi.org/10.2172/369699· OSTI ID:369699
The Environmental Protection Agency and the Department of Energy are conducting chemical evaporation rate experiments in the DOE`s Liquefied Gaseous Fuels Spill Test Facility (LGFSTF) wind tunnel to determine the effect on evaporation rate of pool temperature and wind speed. Evaporation rates measured in these tests will be used to verify mathematical models used to define the source (gas) rate inputs to dispersion models. In preparation for the experiments the LGFSTF tunnel has been modified to provide for the simulation of an atmospheric boundary layer flow on the tunnel floor. This report describes work performed by the DOE Modeling Support Center at the University of Arkansas to define (characterize) the turbulence properties in the boundary layer of the (modified) wind tunnel test section. Hot wire anemometry measurements were made to characterize the boundary layer flow over the evaporation test pan. Mean velocity and turbulence statistics were measured along a verticle line (extending from 0.5 cm to 60 cm above the tunnel floor) located on the tunnel centerline immediately upwind of the evaporation pan. The x-direction mean velocity data were analyzed to estimate the applicable values of the surface roughness and friction velocity for four tunnel (variable frequency controller) speed settings: 15 Hz, 30 Hz, 45 Hz, and 60 Hz.
Research Organization:
Arkansas Univ., Fayetteville, AR (United States)
Sponsoring Organization:
USDOE, Washington, DC (United States)
DOE Contract Number:
FG01-94FE63182
OSTI ID:
369699
Report Number(s):
DOE/FE/63182--T2; ON: DE96014470
Country of Publication:
United States
Language:
English