Correlation between microstructure and residual stress formation in friction stir welded armor steels characterized by neutron diffraction

Journal Article · Sat Feb 28 19:00:00 EST 2026 · Journal of Materials Processing Technology

DOI:https://doi.org/10.1016/j.jmatprotec.2026.119198· OSTI ID:3013498

Guzman, Jhoan ^[1]; Riffel, Kaue ^[1]; Mcdonnell, Martin ^[2]; Bunn, Jeffrey R ^[3]; Payzant, Andrew ^[3]; Kyle, Doug ^[3]; Ramirez, Antonio ^[1]

---

1. Ohio State University
2. TARDEC
3. ORNL

Friction stir welding (FSW) is a solid-state joining process that minimizes the heat-affected zone (HAZ) compared with fusion-based arc welding, making it well suited for joining martensitic armor steels where hardness and ballistic resistance are critical. This study investigates residual stress formation in three defect-free FSW butt-joint configurations relevant to armored-vehicle fabrication: similar rolled homogeneous armor (RHA–RHA, Case 1), similar high-hardness armor (HHA–HHA, Case 2), and dissimilar HHA–RHA (Case 3) joints produced under temperature-controlled conditions (770 °C). Neutron diffraction was employed to quantify the magnitude and spatial distribution of residual stresses in the longitudinal, transverse, and normal directions and to correlate them with weld microstructure and hardness. Tensile residual stresses were concentrated in the softened HAZ, reaching approximately 300 MPa for Case 2 and 400 MPa for Case 1 (≈50–70 % of the base-metal yield strength; ∼581 MPa for RHA and ∼566 MPa for HHA), while compressive residual stresses dominated the stir zone. The spatial extent of tensile stresses scaled with the width of the softened HAZ, which was largest in the dissimilar HHA–RHA joint and smallest in the HHA–HHA joint. Full-width-at-half-maximum (FWHM) analysis revealed low microstrain in overtempered HAZ regions and high microstrain in the stir zone associated with severe plastic deformation and fresh martensite formation. This work demonstrates that residual stress evolution in FSW of martensitic armor steels is governed not primarily by peak temperature or thermal contraction, as inferred from fusion-welding analogies, but by the competition between transformation-induced volumetric expansion and tempering-induced stress relaxation. The relative dominance of these mechanisms is shown to depend on alloy hardenability and local thermal history, leading to more extensive HAZ softening and broader tensile stress regions in the lower-hardenability RHA steel. These findings establish a transferable mechanistic framework for optimizing solid-state joining strategies in high-strength steels and other transformation-hardening alloys beyond armor applications.

• Research Organization: Oak Ridge National Laboratory (ORNL), Oak Ridge, TN (United States)
• Sponsoring Organization: USDOE Office of Science (SC), Basic Energy Sciences (BES) (SC-22); USDOE
• Grant/Contract Number: AC05-00OR22725
• OSTI ID: 3013498
• Journal Information: Journal of Materials Processing Technology, Journal Name: Journal of Materials Processing Technology Vol. 349
• Country of Publication: United States
• Language: English