Surface waviness resulting from single point diamond dressing in cylindrical grinding
This paper describes an experimental investigation of workpiece surface waviness that stems from poor single point diamond wheel dressing procedures in cylindrical grinding. If done improperly, single point dressing can produce a thread on the grinding wheel surface that is then imposed on the workpiece during machining. The circumferential waviness exhibited by the threaded workpiece is similar to that resulting from one per rev vibrations of the grinding wheel. In order to differentiate between these two sources of waviness, a geometrical approach to predicting the circumferential and axial waves produced during grinding is presented. The concepts presented are illustrated through a series of plunge grinding tests incorporating dressing procedures of varying quality. Test results verify that dressing induced circumferential waviness is similar to waviness resulting from one per rev type vibrations of the grinding wheel. The two sources can be distinguished, however, through examination of the workpiece waviness in the axial direction.
- Research Organization:
- Sandia National Labs., Albuquerque, NM (United States)
- Sponsoring Organization:
- USDOE, Washington, DC (United States)
- DOE Contract Number:
- AC04-94AL85000
- OSTI ID:
- 251353
- Report Number(s):
- SAND--96-0814C; CONF-960846--1; ON: DE96008166
- Country of Publication:
- United States
- Language:
- English
Similar Records
Modelling of Metal Removal in Reverse Zones in the Process of Internal Grinding
Application of electrolytic in-process dressing for high-efficiency grinding of ceramic parts. Research activities 1995--96