A superconducting direct-current limiter with a power of up to 8 MVA
- National Technical Physics and Automation Research Institute (Russian Federation)
A resistive switching superconducting fault current limiter (SFCL) for DC networks with a nominal voltage of 3.5 kV and a nominal current of 2 kA was developed, produced, and tested. The SFCL has two main units—an assembly of superconducting modules and a high-speed vacuum circuit breaker. The assembly of superconducting modules consists of nine (3 × 3) parallel–series connected modules. Each module contains four parallel-connected 2G high-temperature superconducting (HTS) tapes. The results of SFCL tests in the short-circuit emulation mode with a maximum current rise rate of 1300 A/ms are presented. The SFCL is capable of limiting the current at a level of 7 kA and break it 8 ms after the current-limiting mode begins. The average temperature of HTS tapes during the current-limiting mode increases to 210 K. After the current is interrupted, the superconductivity recovery time does not exceed 1 s.
- OSTI ID:
- 22612528
- Journal Information:
- Physics of Atomic Nuclei, Vol. 79, Issue 14; Other Information: Copyright (c) 2016 Pleiades Publishing, Ltd.; Country of input: International Atomic Energy Agency (IAEA); ISSN 1063-7788
- Country of Publication:
- United States
- Language:
- English
Similar Records
Fabrication and Tests of a Resistive-Type Superconducting Fault Current Limiter Module Based on Coated Conductors
Transmission Level High Temperature Superconducting Fault Current Limiter