Proton Range Uncertainty Due to Bone Cement Injected Into the Vertebra in Radiation Therapy Planning

Journal Article · Sat Oct 01 00:00:00 EDT 2011 · Medical Dosimetry

DOI:https://doi.org/10.1016/j.meddos.2010.05.005· OSTI ID:21590479

Lim, Young Kyung ^[1]; Hwang, Ui-Jung ^[2]; Shin, Dongho ^[2]; Kim, Dong Wook ^[2]; Kwak, Jungwon ^[3]; Yoon, Myonggeun; Lee, Doo Hyun; Lee, Se Byeong; Lee, Sang-Yeob ^[2]; Park, Sung Yong ^[4]; Pyo, Hong Ryeol ^[1]

---

1. Department of Radiation Oncology, Institute of Health Sciences, Gyeongsang National University, Jinju (Korea, Republic of)
2. Proton Therapy Center, National Cancer Center, Goyang, Gyeonggi (Korea, Republic of)
3. Department of Radiation Oncology, Asan Medical Center, Seoul (Korea, Republic of)
4. Department of Radiation Oncology, Samsung Medical Center, Seoul (Korea, Republic of)

We wanted to evaluate the influence of bone cement on the proton range and to derive a conversion factor predicting the range shift by correcting distorted computed tomography (CT) data as a reference to determine whether the correction is needed. Two CT datasets were obtained with and without a bone cement disk placed in a water phantom. Treatment planning was performed on a set of uncorrected CT images with the bone cement disk, and the verification plan was applied to the same set of CT images with an effective CT number for the bone cement disk. The effective CT number was determined by measuring the actual proton range with the bone cement disk. The effects of CT number, thicknesses, and position of bone cement on the proton range were evaluated in the treatment planning system (TPS) to draw a conversion factor predicting the range shift by correcting the CT number of bone cement. The effective CT number of bone cement was 260 Hounsfield units (HU). The calculated proton range for native CT data was significantly shorter than the measured proton range. However, the calculated range for the corrected CT data with the effective CT number coincided exactly with the measured range. The conversion factor was 209.6 [HU . cm/mm] for bone cement and predicted the range shift by approximately correcting the CT number. We found that the heterogeneity of bone cement could cause incorrect proton ranges in treatment plans using CT images. With an effective CT number of bone cement derived from the proton range and relative stopping power, a more actual proton range could be calculated in the TPS. The conversion factor could predict the necessity for CT data correction with sufficient accuracy.

• OSTI ID: 21590479
• Journal Information: Medical Dosimetry, Vol. 36, Issue 3; Other Information: DOI: 10.1016/j.meddos.2010.05.005; PII: S0958-3947(10)00072-5; Copyright (c) 2011 Elsevier Science B.V., Amsterdam, The Netherlands, All rights reserved.; Country of input: International Atomic Energy Agency (IAEA); ISSN 0958-3947
• Country of Publication: United States
• Language: English

Related Subjects

61 RADIATION PROTECTION AND DOSIMETRY
ACCURACY
CAT SCANNING
CEMENTS
DOSIMETRY
PHANTOMS
PROTONS
RADIOTHERAPY
VERIFICATION
VERTEBRAE
BARYONS
BODY
BUILDING MATERIALS
COMPUTERIZED TOMOGRAPHY
DIAGNOSTIC TECHNIQUES
ELEMENTARY PARTICLES
FERMIONS
HADRONS
MATERIALS
MEDICINE
MOCKUP
NUCLEAR MEDICINE
NUCLEONS
ORGANS
RADIOLOGY
SKELETON
STRUCTURAL MODELS
THERAPY
TOMOGRAPHY