Application of nanoindentation testing to study of the interfacial transition zone in steel fiber reinforced mortar
- Department of Structural Engineering, Faculty of Engineering Science and Technology, Norwegian University of Science and Technology (NTNU), 7491 Trondheim (Norway)
- Department of Materials Science and Engineering, Faculty of Engineering Science and Technology, Norwegian University of Science and Technology (NTNU), 7491 Trondheim (Norway)
The characteristics of the profiles of elastic modulus and hardness of the steel fiber-matrix and fiber-matrix-aggregate interfacial zones in steel fiber reinforced mortars have been investigated by using nanoindentation and Scanning Electron Microscopy (SEM), where two sets of parameters, i.e. water/binder ratio and content of silica fume were considered. Different interfacial bond conditions in the interfacial transition zones (ITZ) are discussed. For sample without silica fume, efficient interfacial bonds across the steel fiber-matrix and fiber-matrix-aggregate interfaces are shown in low water/binder ratio mortar; while in high water/binder ratio mortar, due to the discontinuous bleeding voids underneath the fiber, the fiber-matrix bond is not very good. On the other hand, for sample with silica fume, the addition of 10% silica fume leads to no distinct presence of weak ITZ in the steel fiber-matrix interface; but the effect of the silica fume on the steel fiber-matrix-aggregate interfacial zone is not obvious due to voids in the vicinity of steel fiber.
- OSTI ID:
- 21260494
- Journal Information:
- Cement and Concrete Research, Journal Name: Cement and Concrete Research Journal Issue: 8 Vol. 39; ISSN 0008-8846; ISSN CCNRAI
- Country of Publication:
- United States
- Language:
- English
Similar Records
Aggregate-cement paste transition zone properties affecting the salt-frost damage of high-performance concretes
Cathodic protection of steel reinforced concrete facilitated by using carbon fiber reinforced mortar or concrete