Mechanical properties of reconstituted Australian black coal
- Monash University, Clayton, Vic. (Australia). Dept. of Civil Engineering
Coal is usually highly heterogeneous. Great variation in properties can exist among samples obtained even at close proximity within the same seam or within the same core sample. This makes it difficult to establish a correlation between uniaxial compressive strength (UCS) and point load index for coal. To overcome this problem, a method for making reconstituted samples for laboratory tests was developed. Samples were made by compacting particles of crushed coal mixed with cement and water. These samples were allowed to cure for four days. UCS and point load tests were performed to measure the geomechanical properties of the reconstituted coal. After four days curing, the average UCS was found to be approximately 4 MPa. This technical note outlines some experimental results and correlations that were developed to predict the mechanical properties of the reconstituted black coal samples. By reconstituting the samples from crushed coal, it is hoped that the samples will retain the important mechanical and physicochemical properties of coal, including the swelling, fluid transport, and gas sorption properties of coal. The aim is to be able to produce samples that are homogeneous with properties that are highly reproducible, and the reconstituted coal samples can be used for a number of research areas related to coal, including the long-term safe storage of CO{sub 2} in coal seams.
- OSTI ID:
- 21212699
- Journal Information:
- Journal of Geotechnical and Geoenvironmental Engineering, Vol. 135, Issue 7; ISSN 1090-0241
- Country of Publication:
- United States
- Language:
- English
Similar Records
EFFECTS OF SAMPLE SIZE ON THE STRESS-PERMEABILITY RELATIONSHIP FOR NATURAL FRACTURES
Clean Coke Process. Process development studies report for first quarter 1978